Driver side exhaust manifold.
Driver side exhaust manifold.
The 1988 Toyota oxygen sensor is located on the air cleaner housing. You will find the sensor, on the back side of the housing.
It is in the distributor.
On top of the exhaust manifold on the drivers side.
The oxygen sensor in a 1988 Cadillac Deville is located in the exhaust manifold. It constantly monitors oxygen levels in the exhaust to allow the engine to operate and peek efficiency.
The 1988 Dodge Dynasty coolant fan sensor is located a few inches above the thermostat housing. The thermostat housing can be found on the front of the engine.
If your 1988 Chevrolet Celebrity has the V6 engine the oxygen sensor is in the middle of the exhaust manifold nearest the firewall. If you have the 4 cylinder engine the oxygen sensor is located in the exhaust manifold just above the exhaust pipe flange.
The oxygen sensor on a 1988 Honda Prelude fuel injected engine is on the exhaust manifold. It screws directly onto the front of the exhaust manifold.
The oxygen sensor on a 1988 Astrovan is located in the exhaust system. There are two oxygen sensors, one on the driver's side and one on the passenger side of the exhaust.
in the exhaust manifold right before the catalytic converter
where is the crankshaft sensor located on a 1988 cutlass supreme
There are two. They are in the exhaust system. One is before and one is after the catalytic converter.
In a 1988 Jeep 4.0, the oxygen sensor is typically located on the exhaust manifold or the exhaust pipe, just downstream of the manifold. It may be found near the front of the vehicle, close to the engine. Depending on the specific model and exhaust configuration, there might be one or two oxygen sensors, with the second potentially located further down the exhaust system.