0
The PCV Valve is located right beside the EGR valve (located in behind but attached to the intake manifold) and has a thick black tube connected to it, when that tube is removed, it will expose the PCV valve from there, you will have to unscrew it and replace it, then re connect the hose and start it up! Trust me it sounds a lot easier than it really is! It takes almost 90 mins to reinstall! I am not sure it will work on all Villagers!
On a 2000 Villager, the PCV valve is pressed into a rubber grommet on a 90 degree tube extension from the rear valve cover, which is then connected by a black hose to a nipple extension on the upper rear intake manifold. The way to remove it is to unbolt the bracket attached to the intake manifold holding the accelerator cable, using 'right angled' pliers to open, then push the hose clamp back from the end of the hose attached to the intake manifold, then using the angled end of a brake shoe adjusting tool to push off the hose from the nipple on the rear upper intake manifold, being careful not to break off this nipple (the upper intake manifold is molded plastic and the nipple is part of the manifold). Once this end of the hose is loose, then the PCV valve with the hose attached can be pulled out of the grommet from the valve cover end.
It helps to place a little silicone grease onto the manifold end of the hose and the base of the PCV valve that slides into the grommet for ease of future removal. Replace the hose clamp, replace the accelerator cable bracket, and you're ready to go. Make sure you do this with the engine cold, because there isn't a lot of room in the back of the engine. It took about 10-15 minutes to do it this way.
What else can I help you with?
Is a PCV valve expensive for a mercury villager 94?
No, it's not.
Where is located the PCV valve on a mercury villager 2000?
It's on the throttle body.
Where is the PCV valve on a 1993 mercury villager?
It's mounted on the throttle body.
Where is the pcv valve on a 97 Mercury Villager van?
It's located on the back side of the intake manifold. It's screwed into the manifold.
Where is the PCV value located on a 2001 Mercury Villager?
it is on the back valve cover, you can't see it unless you remove the intake plenum.
Where is the PCV valve on a 1997 Mercury Mountaineer?
The 1997 Mercury PCV valve is located on the outside of the air cleaner housing. The PCV valve can be found on the back of the housing.
Where is the PCV valve on the 2001 mercury sable duratec engine?
The 2001 Mercury Sable PCV valve can be found on top of the engine. The PCV valve will be on the back side of the air cleaner housing.
How do you find the PCV valve on 1998 Mercury Villager with a 3.0 V-6 engine?
It is located on the back side of the upper intake plenum under the cowl.
How do you find the PCV valve on 1998 Mercury Villager with a 3.0 V 6 engine?
It is located on the back side of the upper intake plenum under the cowl.
Is there a PCV valve on a 1997 Mercury Villager SE 3.0 FI and where is it located?
it is located at your valve cover driver side on the end of the hose the pcv valve is pluged into the valve cover at the end of the hose you may have to use a screwdriver to pry it out of the hole. is it a straight blk hose the goes to the fuel rail
Where is the coolant air bleed valve on 2000 Mercury Villager?
The Villager engine does not have a coolant bleed valve.
Where is the pcv valve located on a 1999 mercury villager 3.3 liter?
it is in the back of vavle cover on firewall side. you can't see it unless you remove the intake plenum.
