answersLogoWhite

0

In the computer.

User Avatar

Wiki User

21y ago

What else can I help you with?

Related Questions

Where is quad driver located at on Oldsmobile Cutlass Calais S 2.3?

In the computer.


Where is the starter located on a 1991 Olds Calais S Quad 4 engine?

Look in front lower of engine behind radiator


What motors interchange with 1988 Oldsmobile calais 2.3?

The Oldsmobile Calais, also known as the Cutlass Calais, was produced by General Motors from 1985 to 1991. In 1987, the Quad 4 engine was developed and the 1988 Calais was fitted with it. All?æof the Quad 4 14 engine types of the 2.3 liter version are interchangeable on the 1988 Calais.


You got a code 26 Quad Driver Module do you change your whole computer what should you do I have a 1993 Ccamaro Z28?

I would take it to a repair shop and have them check it out. If indeed the quad driver is defective you will have to replace the computor.


Your 1992 Buick Century has a DTC 26 code how can you find out what this is?

A DTC #26 is a Quad Driver Module Malfunction.


How do you set the timing in a 1990 olds calais 2.3L quad 4?

To set the timing on a 1990 Olds Calais with a 2.3L Quad 4 engine, first ensure the engine is at TDC (top dead center) for cylinder one on the compression stroke. Then, locate the timing mark on the crankshaft pulley and the timing tab on the engine. Use a timing light to check the timing; if adjustments are needed, loosen the distributor hold-down bolt and rotate the distributor until the timing light indicates the desired timing mark. Finally, retighten the distributor bolt and recheck the timing to ensure it remains in the correct position.


How do you change the water pump on a 89 olds Calais with quad 4 motor?

To change the water pump on a 1989 Oldsmobile Calais with a Quad 4 motor, first disconnect the negative battery terminal. Remove the serpentine belt by loosening the tensioner, then drain the coolant from the radiator. Unbolt the water pump from the engine block, clean the surface, and install the new pump with a new gasket. Reassemble everything in reverse order, refill the coolant, and reattach the battery terminal.


Where is the Qaud Driver module located on a 1991 Buick Century Custom?

Quad drivers are small chips that perform on off functions inside the Engine Control Module. If you have a code which states there is a Quad Drivers Error, you need to check the items that that particular Quad Driver is controlling. For example, the a/c compressor relay, or trans solenoids etc...


What does obdII code 1655 97 Pontiac Grand Prix?

P1655 refers to the Powertrain Control Module fault (quad driver 2)


How do you replace the starter of a 1989 calais quad 4?

You have to remove the intake manifold and be care full of the crank sensor


How can i fix the quad driver module on a buick park avenue 1993?

the quad driver module is a component of the ECM. you must replace ECM.


How hard to replace starter on 91 Olds Calais S Quad 4?

Replacing the starter on a 1991 Oldsmobile Calais with a Quad 4 engine can be moderately challenging, especially if you're not familiar with automotive repair. The starter is located in a tight space, which may require removing other components for better access. Basic tools and some mechanical knowledge are necessary, but it’s manageable for someone with DIY experience. Always ensure the battery is disconnected before starting the replacement to avoid any electrical hazards.