answersLogoWhite

0

on the 2006 models of the Ford Fusion. the radio antenna is embedded in the back glass with the rear defrosters. It's important to know that when installing aftermarket radio you should connect pin 5 on the radio harness to a switched 12v source. If not done this will cause problems with radio reception! pin 5 is the antenna's booster power wire and was originally powered off of the stock radio but the aftermarket radios do no supply this power source. I reccommend using a relay and the remote antenna wire and 12v constant wires off the new radio harness to make this connection! this will allow the the remote wire to switch the relay on and off when the radio powers on, and connect the the tapped 12v constant wire to the antenna booster power! thats how i would do it!

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

How do you replace a antenna on a 2006 Chevy Malibu maxx?

To replace the antenna on a 2006 Chevy Malibu Maxx, start by removing the old antenna by unscrewing it from the base, which is typically located on the rear of the vehicle. If the antenna is a powered type, you may need to disconnect the wiring harness. Once the old antenna is removed, screw in the new antenna securely and reconnect any wiring if applicable. Finally, test the radio to ensure the new antenna is functioning properly.


Where is the throttle position sensor located on a 2006 Ford Fusion?

where is the throttle position sensor located on the 06 ford fusion


How to Remove radio 2006 Monte Carlo?

Begin by removing the radio retaining cover. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness and the antenna cable from the back of the radio.


Where is the radio antenna on your 2006 Ford Expedition Limited?

Inside the passengers side, rear side window on the Expedition.


How to replace te radio on a Chevrolet Nubira 2006?

Remove the radio retaining cover. Remove the radio retaining bolts. Remove the wiring harness and the cable antenna from the back of the radio. Reverse the process to install the new radio.


Where is the radio antenna located on a 2006 land rover discovery 3?

Well, isn't that a happy little question! On a 2006 Land Rover Discovery 3, the radio antenna is typically located on the roof of the vehicle towards the rear. It's important to take good care of it so you can continue to enjoy all the beautiful music and stories it brings into your journey. Just like painting, paying attention to the little details can make all the difference!


How do you replace the radio and clock light on a 2006 Ford Fusion?

To replace the radio and clock light on a 2006 Ford Fusion, first, disconnect the car battery for safety. Remove the trim panel around the radio by gently pulling it away, then unscrew the radio unit from its mounting. Replace the burnt-out bulb with a new one, ensuring it fits securely, and reassemble the radio and trim panel. Finally, reconnect the battery and test the lights to confirm they are working.


Where is located the evaporator temperature sensor in the dashboard of a 2006 Ford Fusion?

inside evaporator case


Are there any shorter antennas available for a 2006 Focus that wont reduce the radio reception?

Yes you can buy a stubby antenna off E BAY.


How do replace mast antenna base on 2006 Pontiac vibe?

To replace the mast antenna base on a 2006 Pontiac Vibe, first, remove the interior headliner or trim panel near the antenna base to access the mounting screws. Disconnect the antenna cable from the base, then unscrew the old base and replace it with the new one, ensuring it's securely fastened. Reconnect the antenna cable and reattach the interior components. Finally, test the radio reception to confirm the installation was successful.


Where is the satellite radio antenna location in the 2006 Jeep Wrangler?

The antenna is in the middle of the roll bar by the sound bar. It faces up and the wire will run down the roll bar and under the carpet to the dash and then to the radio. In 07 the antenna is in the middle of the dash and under the coin area. This doesn't seem to work as ell as the mount on the top of the center roll bar in the 06 models


How do you change light in 2006 Ford Fusion radio?

It's surface-mount LEDs. If you know how to solder, they're green PLCC2 LEDs.