0
First, make sure your gas cap is tight. It might take 20 mins of driving after tightening for the light to go out. Check the gasket on it too to make sure it doesn't leak air. Replace if there is any doubt.
A service engine light means you have a problem that needs repairing. If you have already checked out the problems and corrected them, disconnect the negative cable from your battery for 1 minute. If the light comes back on after reconnecting the battery, you still have an unresolved engine problem.
additional info : there is no "reset button". The trucks Computer Monitors various systems and if it senses a problem it turns on the light. The computer also stores codes that can be read and interpreted giving you a hint as to what the problem is. When the problem is fixed the computer should show no issues and the light will not light up. If you have a truck with a digital tripmeter/odometer on the dash you can access all the engine codes by pushing the reset button while you start the engine. After the engine starts continue pushing the reset button to display things such as a digital tachometer, water temp etc etc. This is there because the computer is generic to all trucks but not all trucks have the fancy option package of showing this info on a separate screen. What you are seeing is what the dealer would see with his diagnostic computer. It is all alpha numeric and makes no sense but you can find explanations to all this on several websites dealing specifically with Ford trucks. Its out there on the web, you just have to dig. Good luck.
What else can I help you with?
What about a 2003 gallant does it have a reset button after you change the oil for service engine light?
There is no reset button for the check engine light. You can have Mitz. do it for $$$ or you can remove the negative battery line for a few seconds and replace. That will reset the check engin light.
Resetting vsc and engine service light 200 rav 4?
You can reset your engine service light by holding in the scroll button. Hold the button in until the engine oil life goes to 100 percent. The engine service light will go off.
How do you reset a service engine light on a 2003 range rover?
reset service engine light
How do you reset the service light on a Kubota?
To reset the service light on a Kubota tractor, first turn the ignition key to the "on" position without starting the engine. Next, press and hold the "Hour Meter" button or the "Service" button, depending on the model, until the service light blinks and then turns off. Release the button, and the service light should be reset. Always consult your owner's manual for model-specific instructions.
Why after you hit the reset button the check engine light is still blinking repeatedly?
There is no reset button for the check engine light. It must be reset with an OBD scan tool.
How do you reset service light on Renault megane 2003?
To reset the service light on a 2003 Renault Megane, turn on the ignition without starting the engine. Press and hold the trip reset button on the dashboard until the service light begins to flash, then release the button. After a few seconds, the light should turn off. If it doesn't, repeat the process to ensure the reset was successful.
How do you reset the service engine soon light in a 2001 Pontiac Grand AM GT?
You can usually disconnect the battery cable for about 15 seconds and reconnect it to reset the engine light. Check the fuse box for a(red) resert button - to reset the engine light disconnect battery for 15 minutes , the red reset button on fuse panel is for motor oil change reminder reset
Is there a reset button for the check engine light on a 1986 BMW 325?
Unfortunately a 1986 BMW 325 does not have a service light reset button. To reset the light a user can ground pin 7 in the diagnostic connector. Doing so automatically sends a signal to the cars ECU to reset all error codes and service lights.
How do you reset check engine light on Volvo XC90?
Turn key to accessory position. Press and hold trip meter reset button. Wait half a second and turn key to on position (not start) continuing to hold trip button. After a few seconds the service light will start flashing. At this point release the trip button, cycle the key and start the engine. The service light should be reset.
How Do you reset the Engine Service light on a 1996 Infiniti I30?
A reset Engine Service Light comes on when an issue comes up with in the engine. This light can be reset by a tech or by fixing the problem.
How do you reset service engine soon light on a 2003 325i BMW?
reset service engine light on BMW 325
Were is the reset button for the check engine light for a 2000 Olds Bravada?
The light is reset with a scan tool after the repair. There is not a button.
