0
What else can I help you with?
How do you replace a slave cylinder on a 88 bronco fullsize?
To replace the slave cylinder on a 1988 Ford Bronco Fullsize, first, ensure the vehicle is securely lifted and supported. Drain the hydraulic fluid from the clutch system, then disconnect the hydraulic line from the slave cylinder. Remove the mounting bolts securing the slave cylinder to the transmission and pull it out. Install the new slave cylinder, reattach the hydraulic line, and refill the hydraulic fluid before bleeding the system to remove any air.
Why would clutch fluid leak out on a 88 Toyota corolla?
Bad clutch slave cylinder or failed soft hose from master to slave cylinder.
88 Ford Ranger firing order 4 cylinder?
www.motorcraft.com shows : 2.0 L 4 cylinder and 2.3 L 4 cylinder engine firing order as ( 1 - 3 - 4 - 2 ) The distributor rotor turns CLOCKWISE
Where is the 4x4 switch on a 1989 Ford Ranger?
on the 88 ranger the switch is above your rearview mirror located on the ceiling on the 88 ranger the switch is above your rearview mirror located on the ceiling
What is the spark plug gap for a 88 ford ranger?
The spark plug gap for the 2.3 litre 88 ranger is .035. This information can be found on the decal inside the engine compartment.
What if your 88 accord lxi is leaking clutch fluid?
your slave cylinder is bad,its bolted on to transmission,replace and bleed system.
Which cylinder is number one on a 88 ford 302?
firewall 4 - 8 3 - 7 2 - 6 1 - 5 front of Ford
What is the firing order for a 88 Ford Ranger 2.8L?
For the ( 2.9 ) liter V6 engine in a 1988 Ford Ranger : The firing order is ( 1 - 4 - 2 - 5 - 3 - 6 ) The distributor rotor turns CLOCKWISE The marked # 1 position on the distributor cap faces towards the REAR The engine cylinder locations are numbered : firewall 3 - 6 2 - 5 1 - 4 front of vehicle * the 2.8 liter V6 engine in , say a 1985 Ford Ranger , has the same firing order
How do you charge the ac in your 88 ford ranger?
Will have to be converted to 134 buy a conversion kit at Wal-Mart or auto parts comes with instructions
How much horsepower does a 2.3 1978 mustang engine have?
The 1978 Ford Mustang 2.3L inline SOHC four-cylinder has 88 horsepower
Which was the maximum speed of ford pinto wagon manual 4-cylinder 85HP 1973?
The Ford Pinto wagon was produced from the years 1971 to 1980. The maximum speed of a 1973 Ford Pinto wagon manual 4 cylinder 85 HP is around 88 miles per hour.
What temperature thermostat should be in a 1997 Ford Ranger?
190 degrees Fahrenheit ( 88 degrees celsius ) Motorcraft part # RT1140 for the 2.3 L 4 cylinder for the 3.0 L Motorcraft.com lists 2 different part #s depending on application - see a Ford dealer , they are Motorcraft RT1137 or RT1152 Motorcraft part # RT1161 for the 4.0 L OHV
