answersLogoWhite

0

Open the hood and stand on the driver's side of the car, you should see the transmission. In the top right corner there are two 14MM bolts, your starter is back there, after bolts are removed, reach back there and disconnect the wires from the starter then pull it out. Shouldn't be too hard. Not sure on the automatics though.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Can a turbo from a 1989 Ford Probe be used on a 1989 Ford Probe non turbo?

if you have the exhaust manifold, oil lines, etc. from the 89 GT then yes.


What is the lowest price for a turbo charger for a 1989 ford probe?

i will sell you one for 300 3095317145


Are the motor mounts on a 1989 ford probe gt the same as the mounts on a 1989 ford probe lx?

they both should have a 2.2 engin and the gt has a turbo but they are the same and will fit but you might come into some problums with the dash seeing as you have no boost gage for your turbo.


Can you get a picture of the enigine for a 1989 Ford probe GT 2.2 Turbo?

Yes, are you still needing one?


How difficult is it to replace the starter in a Ford Probe It's a 1985?

Probes were not made until 1989


Does anything need to be taken off to remove a starter on 1989 ford probe?

does anything need to be taken off to remove a started on 89 ford probe


Where is the starter solenoid on a 1989 Chevrolet celebrity?

The starter solenoid is located on the top of the starter.


Where is the starter located on a 1989 Chevy Corvette?

== ==


Where is the solenoid to the starter on a 1989 subaru gl 10 turbo?

Solenoids are commonly mounted on the side of the starter. Many are integral to the starter and are difficult, if not impossible, to change or repair. FriPilot


Where is the starter located at on a 1989 Toyota Tercel?

the starter should be under the intake on the back of the motor.


Where are the fusible links located on a 1989 cavalier?

over by the starter


Where is starter on 1989 Ford Probe located?

its in the back, between the firewall and the engine. you have to get underneath the car to remove or install it. there are three bolts. 2 from one direction one from the other. the main positive wire from the battery runs to it.