Starter motors on the Northstar are located in the cylinder valley under the intake manifold. It's a breeze to replace, as it doesn't get dirty and cruddy like most starters. Just be careful pulling the intake manifold off. how do i remove the injectors?
I believe the starter motor sits in the galley under the intake manifold.
If it is the Northstar engine which I believe it is, it is inside the motor under the intake manifold.
NO.
The best ignition wires for the Northstar are the factory recommended AC/Delco OEM replacements. Anything else and you're asking for trouble.
Cadillac Northstar is a a type of motor car engine produced by the American compant Cadillac. Northstar engines can be found in Cadillac garages and via online websites.
the starter is located inside the intake manifold which is under the top cover that says northstar in other words itis inside the motor The starter is under the intake manifold>
Yes.The engine was the same 4600 V8 NorthStar which had 2 versions with different horsepower depending on the model trim.
4.6L Northstar V8
5.7 liter
The starter on the northstar engines are located in the "V" of the block under the fuel injection ports. This starter can be removed by blocking the fuel injection up about three and one half inched above the motor allowing you to remove the battery cable and the two bolts from the starter.Hint: before attempting to remove the starter, make sure the battery cable is clean and making good contact. The starter cable is stacked on top of another cable.
It's close to the blower motor.
it should, but the emissions regulations of the 2002 car are different than that of the 1998 motor