It is located center of vehicle, just to the right of the steering column, mounted in the front of the console.
I have a turn signal light that keeps flashing regardless of the control arm position. I think that the problem is in the turn signal control relay but I don't know where it is located. I did find the 3 prong relay located behind the center console but this is not the problem because I replaced it and have the same problem.
It should be plugged into the fuse panel on the lower left corner. There should be two relays there, the upper one is the turn signal relay and the lower one is the horn relay. Hope this helps!!
On a 2004 Chrysler Sebring, the turn signal relay is typically located in the fuse box, which is found under the dashboard on the driver's side. To access it, you may need to remove a cover to reveal the relays and fuses. The turn signal relay is usually labeled, so check the diagram on the fuse box cover for its exact location. If you're having trouble, consulting the owner's manual can also provide specific details.
where is turn signal relay located at 1989 mercury sable
there is a compartment on the driver side when you open the driver door look by the hinge you will see a panel pull of relay is in there BEHIND A/C AND HEATER CONTROL PANEL, IN CENTER CONSOLE.
Google it.
The starter relay is part of the starter.
Its under back seat
Not used. It is driven by the PCM
If the bulbs and fuse are good, replace the turn signal Flasher Relay.
The turn signal flasher relay switch is located beneath the drivers side dashboard. The turn signal flasher relay switch will be to the left of the brake pedal.
No such part exists on a Sebring, the fuel pump is computer controlled with a relay.No such part exists on a Sebring, the fuel pump is computer controlled with a relay.