On the transmission.
on the dash
The ECM in a 1999 Mercury Sable is located on the inside of the vehicle on the passenger side. It is located under the kick plate.
The speedometer is driven by the vehicle speed sensor. See "Related Questions" below for more about where to find it, and how to replace one.
My auto lamp light sensor is not working on my Mercury Sable 2002. Why?
In a 2001 Mercury Sable, the coolant low sensor is typically located in the coolant reservoir tank. It is a small plastic component that detects the coolant level and sends a signal to the vehicle's dashboard if the level is low. To access it, you may need to remove the reservoir tank from its mounting position. Always consult the vehicle's service manual for specific instructions and safety precautions.
Sounds like you have a bad Vehicle Speed Sensor.
The rear speakers in a 2001 Mercury Sable measure 6 inches by 8 inches. These speakers are located in the rear deck of the vehicle.
On a Mercury Sable , V6 engine : firewall 1-----2-----3 4-----5-----6 front of vehicle > driver
In a 1999 Mercury Sable, the knock sensor is typically located on the engine block, near the intake manifold. It is usually positioned on the driver's side, towards the rear of the engine. To access it, you may need to remove some components for better visibility and reach. Always refer to the vehicle's service manual for exact locations and procedures.
The speed sensor on a 2008 Mercury Sable is typically located on the transmission. Specifically, it can be found on the side of the transmission housing, near the output shaft. To access it, you may need to raise the vehicle and remove any obstructions, such as the air intake duct or other components, for better visibility and access. Always consult the vehicle's service manual for precise location and replacement instructions.
location of engine cooling fan sensor
switch sensor located next to the transmission