In a 2001 Mercury Sable, the coolant low sensor is typically located in the coolant reservoir tank. It is a small plastic component that detects the coolant level and sends a signal to the vehicle's dashboard if the level is low. To access it, you may need to remove the reservoir tank from its mounting position. Always consult the vehicle's service manual for specific instructions and safety precautions.
The coolant sensor is on top of the engine. It is between the ignition coil and the tfi module.
The coolant temperature sending unit on a 97 Mercury Sable is in the engine compartment. It is located on the intake manifold.
on the dash
On the transmission.
My auto lamp light sensor is not working on my Mercury Sable 2002. Why?
On a 2001 Mercury Sable : The thread on cap on the engine coolant reservoir ( located in your engine compartment , on the passenger side of the engine compartment ) is the pressure cap / radiator cap
The coolant level sensor is bad. It is integrated into the coolant bottle, so you need to replace the coolant bottle.
NOTE: this answer is describing the location of the engine coolant temperature sensor - NOT the coolant sensor in the reservoir that warns when the level gets too low.The coolant temperature sensor is located directly adjacent to the thermostat housing. The thermostat housing is what the upper radiator hose (toward the right side of the engine compartment) connects to. You do not have to replace the reservoir to replace this part, but leaky coolant reservoirs are a common problem on this model.
location of engine cooling fan sensor
switch sensor located next to the transmission
where is turn signal relay located at 1989 mercury sable
Where is the starter located on a 1997 mercury sable ,and if any display a photo of the part.