In the wheel hub along with the wheel bearing.
The typical ohm reading for a wheel bearing sensor (also known as a wheel speed sensor) on a 2003 Buick Rendezvous is usually between 800 to 2,000 ohms. However, it’s important to consult the specific service manual for your vehicle, as variations can occur based on manufacturing tolerances and sensor conditions. If the reading falls outside this range, it may indicate a faulty sensor.
There is a vehicle speed sensor (VSS) and 4 ABS wheel speed sensors, one at each wheel.
I just purchased the throttle sensor for a 2003 Buick rendezvous and was wondering if anyone could tell me where it located and how easy is it to put in.
It is on front/rear hub assy - bearing, studs and wheel speed sensor
To change the vehicle speed sensor on a 2003 Buick Rendezvous, first, disconnect the negative battery cable to ensure safety. Locate the speed sensor, which is typically found on the transmission; remove the electrical connector and the mounting bolt securing the sensor. Pull out the old sensor and replace it with the new one, securing it with the bolt and reconnecting the electrical connector. Finally, reconnect the battery cable and start the vehicle to ensure proper function.
I have an 03 grand am gt, the speed sensors are built into the hub assembly on each wheel.
I have an 03 grand am gt, there is only one way to check out the speed sensor, bring it to a garage and have them scan it for you... this will get it correct.
what is a etc sensor for a buick rendevous
How far off is it? Did you change tire/wheel size? Bad speed sensor.
Find out what the problem is. In my experience, it's usually a bad wheel speed sensor.
Left Front Wheel Speed Sensor Circuit Failure
where is the speed sensor located on 2003 Toyota matrix