I just purchased the throttle sensor for a 2003 Buick rendezvous and was wondering if anyone could tell me where it located and how easy is it to put in.
how to replace the throttle position sensor on a 97 nissan altama
How to replace throttle sensor kia spectra 2003
To change a throttle position sensor on a 1998 Bravada, disconnect the negative battery cable. Separate the wiring harness connector on the throttle position sensor and take off the sensor. Replace with new.?æ?æ
you dont!
There is no adjustment, they are electronic. You just replace them.It senses the position of the throttle and sends the information to the computer.
It is a part of the throttle body. You have to replace the throttle body if faulty.
The throttle position sensor, TPS should be in about the same position as it was in earlier models - so the "Related Question" below should also be helpful.
The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.
The throttle position sensor is in the throttle body.
The throttle position sensor is on the drivers side of the throttle body. It is right in the middle with a connector hooked to it and two torx head screws holding it in.
how do you replace a 2004 buick rendezvous input speed sensor
The throttle position sensor can be removed by dismantling the chassis in which it sits. This can be done by referencing the owner's manual f the Pontiac Montana.