bottom left hand side of the motor, right at the back
bottom left hand side of the motor, right at the back
right side of engine, what is the particular problem with it ?
To change the starter motor on an EF Falcon, first, ensure the battery is disconnected to prevent electrical issues. Remove the starter motor by unbolting it from its mount and disconnecting the electrical connections, including the main power cable and the solenoid wire. Install the new starter motor by reversing the removal process, ensuring all connections are secure, and finally reconnect the battery. Test the installation by starting the engine to confirm proper function.
the starter motor is behind the intake manifold. after you take the main intake shield, there is another shield that covers the starter motor. remove the starter shield and you can find the motor. its a little hard that other cars i used to have but it can be worked on. just need a little more patience.
In the Ford Falcon, the starter motor is typically located near the bottom of the engine, mounted to the transmission bell housing. It is usually positioned on the driver's side, making it accessible for replacement or inspection. Depending on the specific model and year, the exact location may vary slightly, but it generally remains in the same area across different versions of the Falcon.
No, you cannot use a starter rated for a 5 hp motor with a 7.5 hp motor. The starter needs to be matched to the motor's horsepower rating to ensure proper protection and operation. Using an undersized starter can lead to overheating and premature failure of the motor. It is recommended to use a starter specifically designed for a 7.5 hp motor.
possible crook ign. switch contacts or crook starter motor.
The easiest way to change them is on a hoist. if you dont have acess to one jack up the front of the car and put stands under it.disconnect the batterythere will be two bolts going through the starter into the bellhousing, remove the two bolts. they should be 13mmonce you remove the starter remove the wires attached to the solenoid making sure to take note of where the wires go.it is easier to remove the wires once the starter is out as you will have more room.when you put the new starter in put the wires on firstfit the starter then reconnect the batteryRead more: http://www.justanswer.com/questions/1woj2-change-starter-motor-ford-falcon#ixzz0TUgd4eNV
A 1981 Chevy starter will cost approximately $125. The starter can be found at discount auto-parts stores for as little as $80.
The starter motor on a Falcon AU is typically located at the rear of the engine, near the transmission bell housing. To access it, you may need to lift the vehicle and remove the protective cover if present. It's usually bolted in place and connected to the battery via thick cables. Always ensure the vehicle is safely secured before attempting any maintenance.
it could me bad fuel ..or fuel pump
The starter motor is at the rear of the engine.