answersLogoWhite

0

possible crook ign. switch contacts or crook starter motor.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you replace the ignition switch in a 1964 Ford Falcon?

on a 1963 Falcon..first remove the key insert by turning key allthe way to the left,. Then place a paper clip(straightend) into the hole in insert.Press in to release the spring while turning key farther to the left and remove insert..now the ignition swithch can be removed by pressing in from rear of dash and turn switch counter clockwise while holding switch retainer in from front..


Where is the ignition module on xg falcon?

ignition module is inside distributor along with hall sensor


Ea falcon no spark?

could be distributor, coil or ignition module. usually the ignition modules fail first on them.


Where is the ignition coil on a Ford Falcon EL 98?

In the distributor housing


Where is the fuel pump on a 1961 Ford Falcon?

It is bolted to the side of the engine block next to the ignition coil.


No spark from coil on eb Ford Falcon?

Crook Ignition module. Guaranteed. Bolts onto side of distributor.


What is a red hand warning light on a Ford Falcon?

I have a AU Falcon the Red Hand on my Dash under the Fuel gauge represents the Smart Lock eg. Imobilizes the Ignition system (Anti Theft).


How do you set the ignition timing on a 6 cylinder ford ef falcon?

You can't the computer does it, just get electronic diagnostic check


How do you replace the ignition coil on an au falcon?

usually buy pulling the old one off and putting new one in its place


Why won't my ford falcon 1999 Au not turn over or fire to start after the ignition barrel was changed?

The barrel is not timed properly to the switch.


Wiring a aftermarket ignition switch for a 1961 Ford Falcon?

http://www.tocmp.com/tOCMP/wiring/5765wiring%20diagrams/Ford/MWire5765-181.jpg


Why does my El falcon missfire at low rpm under load?

Check the ignition leads. 9/10 times one or more of them has started to break down.