0
the OBD1 connector is on the passenger side behind the kick panel. Its most likely bright orange.
The diagnostics terminal for the jumper wire is under the hood mounted to the drivers side wheel well. Jump tabs E1 and TE1 with a wire to make the check engine light flash the codes. Ex. a code 21 is two flashes followed by a pause and then one flash.
What else can I help you with?
Where do you hook up a code reader to a 2000 volvo?
To hook up a code reader to a 2000 Volvo, locate the OBD-II diagnostic port, which is typically found under the dashboard near the driver's side, just above the brake pedal. Plug the code reader's connector into this port. Once connected, turn on the vehicle's ignition (without starting the engine) to power the code reader, allowing it to communicate with the car's onboard computer. Follow the reader's instructions to retrieve any diagnostic trouble codes.
Where to plug a code reader in a 1996 Toyota 4 runner?
To plug in a code reader for a 1996 Toyota 4Runner, locate the OBD-I diagnostic port, which is typically found under the driver's side dashboard, near the steering column. It may be covered by a small plastic cover or panel that you can easily remove. Once you find the port, connect the code reader, and follow the device's instructions to retrieve any diagnostic trouble codes.
How do you read diagnostic codes Chevy Suburban?
Reading diagnostic codes is easy. The driver plugs the reader/scanner into the diagnostic port of the vehicle, and the scanner/reader will give a code if there is a problem, and tell them the type of problem.
Where do you plug in a code reader on a daewoo tacuma?
To plug in a code reader on a Daewoo Tacuma, locate the OBD-II (On-Board Diagnostics) port, which is typically found beneath the dashboard, near the driver's seat. It is usually situated to the left of the steering column or around the area where the dashboard meets the center console. Once located, simply connect the code reader to the port to access the vehicle's diagnostic information.
How do you reset a diagnostic code on a Ford Fusion?
The diagnostic code should go off when the issue is fixed. You can try disconnecting the battery for a few minutes. Also, it can be reset through a code reader.
Where do you plug in a ODB code reader on a 1995 Toyota corolla which reader do I purchase?
It's a box under your hood labeled diagnostic.
Where to hook up code reader Nissan Murano?
To hook up a code reader in a Nissan Murano, locate the OBD-II (On-Board Diagnostics) port, which is typically found under the dashboard near the driver's seat, just above the brake pedal. Ensure the vehicle is turned off before connecting the code reader. Once connected, turn the ignition to the "On" position (but do not start the engine) to power the reader, allowing you to retrieve diagnostic trouble codes.
Where to plug in a code reader on a 98 es 300 Lexus?
To plug in a code reader on a 1998 Lexus ES 300, locate the OBD-II diagnostic port, which is typically found beneath the dashboard on the driver's side, near the steering column. You may need to remove a cover panel to access it. Once you find the port, simply connect your code reader to it and turn the ignition to the "ON" position without starting the engine to read the codes.
How do you get the diagnostic codes on a 2006 Chrysler Town and Country?
You need a scan tool or code reader to get the codes.
Where do you plug in a diagnostic code reader on a 1998 dodge stratus es?
It is under the dash on the driver side.
What is obd port?
Obd-on board diagnostic. The port is the plug the scan tool or code reader connects to.
How do you reset check engine light on ford 500?
You need a code reader that plugs into car's diagnostic port.
