0
To hook up a code reader to a 2000 Volvo, locate the OBD-II diagnostic port, which is typically found under the dashboard near the driver's side, just above the brake pedal. Plug the code reader's connector into this port. Once connected, turn on the vehicle's ignition (without starting the engine) to power the code reader, allowing it to communicate with the car's onboard computer. Follow the reader's instructions to retrieve any diagnostic trouble codes.
What else can I help you with?
Where is the hook up forcode reader 2002 envoy?
Where to hook code reader 2002 envoy
How do you diagnose check engine Chevy 2000 Monte Carlo?
you have to hook up a special reader to your computer to find out the code.
Where do you hook up an OBDII code reader on a 1985 lebAron?
Your OBD II code reader won't work on that vehicle.
How do you determine the trouble code on a 2000 Honda Accord?
To get stored codes you need a OBD 2 reader or scanner. Or take it to local auto parts store and have them hook it up to there OBD2 scanner
Where do you hook up the code reader on a 2002 Suzuki XL 7?
If you are sitting in the steering wheel the hook up will be located by your right knee under the dash.
Does a obd2 code reader hook up to a 2000 kia sportage.have tried and get an error every time?
yes i use obd2 on all sporatages and it works fine, if your getting an error make sure you put the ignition key in the on but not cranking position. then touch the read button on the code reader. Do not try and read with engine running.
Where do you hook an OBD code reader on a 1997 Mercury Cougar?
passenger side panel, above left knee
How do you turn off service engine soon light in 2000 Pontiac Montana?
u can either buy an OBD2 code reader that has that function, or u can disconnect the battery for a few minutes once u hook it back up the light will be off. BUT because your van is a 2000 u will need an activation code
Where do you hook the code reader on a 1995 Dodge intrepid?
under the driver side of the dash, it is a square 6 pin connecter
How do you clear an error code on a Nissan forklift?
you get a code reader and hook it up to the fuse boc and it will say erase codes and u mass the green button.
Where do you hook up the obd2 code reader on a 1999 ford windstar?
The obd2 plug is under the knee board (under the column).
What is the function of the hook in a literary analysis?
The function of the hook is to get the attention of the reader.
