0
What else can I help you with?
Do you change the oil filter first or drain the oil first?
Drain then change the filter.
Do you take the filter or the oil plug out first?
The oil plug.
Who invented the oil cup?
(1843-1929)Elija McCoy, He invented the first oil cup for trains.
When was the first oil tanker invented?
1849
Why synthetic oil level decreases in car when its poured for the first time?
All oil levels decrease when first poured in and the car is started for the first time. This is because most people just spin on or drop in the filter. The filter itself holds a certain amount of oil. It is for this reason that it is required that you check the oil level when changing the filter.
Who invented the oil pump?
Archimedes, because the first pump technical was invented by him.
How do you change oil filter on 2002 lancer oil filter?
To change the oil filter first drain the old oil. Then use an oil filter wrench, preferably the cup type you put on a ratchet, and unscrew the filter. The filter is located right next to the oil pan, it's pretty obvious what it is. Then take the new filter, rub some oil on the gasket, and hand tighten it. DO NOT tighten with wrench, only hand tighten it! Then fill the car with new oil. All done.
How change scion XD oil filter element?
To change the oil filter element on a Scion XD, first, ensure the engine is cool and the vehicle is on a level surface. Locate the oil filter, which is typically beneath the engine. Use an oil filter wrench to remove the old filter, then apply a bit of new oil to the rubber gasket of the new filter before installing it. Finally, reinstall the oil filter, tighten it securely, and replace the engine oil if necessary.
How much does it cost to change an oil filter on a 1999 Ford Explorer?
First off you would not want to change the oil filter without changing your oil also. A DIY oil change using premium oil and a premium filter will cost you around $15.
Is the oil filter the same as the air filter?
No because oil filter i meant for oil to go on the filter air filter does not need oil
How do you remove the oil filter on my BMW X5 2006?
To remove the oil filter on a 2006 BMW X5, first ensure the engine is cool and then lift the vehicle securely. Locate the oil filter, which is typically located near the oil pan. Use an oil filter wrench to loosen and unscrew the filter, allowing any residual oil to drain into a container. Once removed, clean the filter mounting surface and install the new filter by hand-tightening it before adding fresh oil.
How to change the oil of an 1996 Galant?
drain oil from oil pan,by un-doing oil pan nut, then with oil filter wrench undo filter. Then install new filter and pour oil in were it says "OIL" in the filler cap.Check oil level with dipstick. First time will take about an hour, then after that 20 minutes tops.
