answersLogoWhite

0

Your Idle Air Contol valve (IAC) may need to be cleaned. Refer to the following website for instructions http://www.geocities.com/adamk01452/IAC_Clean.html

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What is the Recommended tire pressure for low pressure tires Mazda 626-2.49 1992?

what is the tyres pressure for Mazda 626-2.48 1992(low pressure tyres)


Why would the handbrake light stay on in a 1993 Mazda 626 when not in use?

Either your handbrake switch is broken and will not turn off or you have low brake fluid.


Where is the low pressure port for the ac system for a 1998 Mazda 626?

The 1998 Mazda 626 low pressure port for your air conditioning system will be on the top of the air conditioner compressor. The low pressure port will be on the left-hand side of the compressor.


Where is the location of the service port for AC recharge on a 1990 Mazda 626?

The 1990 Mazda 626 air conditioning low pressure port can be found on top of the air conditioning compressor. The low pressure port should be labeled.


Where is the low pressure port for the AC system for a 2002 Mazda 626?

it should be in front of the radiator like on my 1998


What is diagnostic code p0117 Mazda 626?

Trouble code P0117 means:Engine coolant temperature circuit,low input


Why does the clutch pedal sometimes stick halfway in on a 1993 Mazda 626?

A clutch pedal that sticks halfway in on a 1993 Mazda 626 can be caused by a few issues, such as low hydraulic fluid in the clutch system, air in the hydraulic lines, or a failing master or slave cylinder. Additionally, worn or damaged components like the clutch release bearing or pressure plate could also contribute to this problem. Regular inspection and maintenance of the clutch system can help identify and resolve these issues. If the problem persists, consulting a mechanic is advisable.


Where is low pressure port of ac 1990 Mazda 626?

WE finally found it on the compresson housing near the "S" suction , large hose connection.


Why does your 93 probe se redline at 4800 rpms?

Due to it's an 4 cyl. Mazda 626 2.0 Liters with a low gear change ratio.


Can you adjust the clutch pedal on a 1999 Mazda 626 It is engaging too close to the floor?

I believe you can but normally when it engages low its a sign that the clutch should be replaced soon.


Mazda RX7 1993 hrd to start and low idle RPM any ideas?

Power fc


Where is the airconditioning low pressure service port for a 2002 Mazda 626?

I have a 99 Mazda 626 and mine is on the passenger side of the car. Look for a black cylinder close to the firewall. You should find a small screwoff cap on the black cylinder. This is where you connect your hose to add freon. The high pressure and low pressure service ports are different sizes, so you can't get them mixed up and connect to the wrong one. Hope this helps!