answersLogoWhite

0

Over reving the engine, ( to many RPM )

The rocker arm nuts need replaced ( The locks are worn out on the nuts )

The rocker arms are worn where they set on the valve stems.

Need to check everything closely.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Do you have too remove the rods and rocker arms on a Chevy 350 before you take off the heads?

PUSH rods and rocker arms... yes.


Changing head gasket do you have to take rocker arms off?

yes


Chevy 350 how to replace push rods?

Pull the valve covers off. loosen the rocker arms with out taking them all the way off. then you can turn the rocker arms to pull the push rods out. replace push rods, and tighten rocker arms back down and put valve covers back on


Do you have to take off the intake manifold to get to the rocker arms on the Chrysler 300?

On the v6, yes


Is it ok for rocker arms not to line up perfect with valves on a 327?

If the heads don't have push rod guide plates, the rocker arms will set off center just a little. But if they are way off then you must have a bent push rod.


How do you remove rocker arms on a 92 Mazda b2200?

To remove the rocker arms on a 1992 Mazda B2200, first, ensure the engine is cool and disconnect the battery. Remove the valve cover by unscrewing the bolts, then carefully lift it off. Next, loosen the rocker arm bolts in a crisscross pattern to avoid warping, and remove them along with any pushrods. Finally, take off the rocker arms from their shafts, noting their arrangement for reassembly.


What causes rocker arms to fall off on dodge ram?

On the 4.7L engine it can be caused by failed lifters.On the 4.7L engine it can be caused by failed lifters.


Will rockerarms off 2200 fit 2000 1989 Mazda truck?

yes they do.use the b2000 cam caps and use the b2200 rocker arms,rocker shafts and shaft springs


Is it normal that there is oil in the magneto cover on Yamaha xt 550?

YES IT IS. THRE IS AN OPEN LOOP INTO THE CRANKCASE AND ALLOWS OIL COMING OFF THE ROCKER ARMS AND OVER THE TIMING CHAIN TO COME DOWN AND RETURN.


2000 Saturn sl2 why rocker arms fell off one side?

Most likely bc a valve broke and hit a cylinder which then pushed the hydraulic lifter up breaking the rocker arm


How do you check a rocker arm on a 2000 Jeep Grand Cherokee Limited with a 4.7 V8 engine?

Rocker Arm problems, specifically with them falling off, are common with 2000 JGC's. You can get the code read, which will point to the cylinder that has the failed rocker arm and then remove the left or right rocker cover to inspect. The problem with the falling off rocker arms tends to be a slippage of the valve guides that leaves the valve to hang up and removes the stress from the rocker so it just falls off. Replace the heads. Replace the HEADS? Sounds drastic. How about repairing the heads?


How do you set the head valves on an 87 s-10?

Tighten the rocker arms down all the way and then losen them 3/4 a round off