0
Normally the brakes start making a noise when the brake pads are worn past a certain point. A wire pops out and they start making a noise. That means the pads are thin and need to be replaced. Since you ignored that noise and waited until they started squeaking, it means you let them get to the point where they wore down to the rivets. They squeak because metal is scratching on metal. Now you have to replace the whole unit and not just the pads. You have an expensive repair job ahead.
What else can I help you with?
1994 Chrysler LHS died on the road and now does not want to start why?
how do you install a crankshaft sensor on a 94 Chrysler lhs....where is it located on a 94 Chrysler lhs???????????????????loisanne0@hotmail.com
Does a 94 Chrysler lhs have a factory alarm?
It was as factory option.
What kind of variable effort steering is the 94 lhs Chrysler?
The Chrysler LHS comes standard with a speed proportional rack and pinion power steering assembly.
Is there a fuel shut off switch for a 94 Chrysler LHS If so where is it located?
Chrysler does not have shut off switches.
Where is the heater core located in a 94 Chrysler LHS?
You have to remove the upper headers and it should be there toward the radiator and the fuel rail
Is there an impact shut off fuel reset button on a 94 lhs?
No.
Why 94 lhs engine shakes when accelarating?
sounds like you have a bad motor mount
What would cause a 94 Chrysler LHS to run hot it's not the thermostat?
This question is not complete. . Need to know if you've replaced radiator, thermostat, hoses etc. Are you asking this question *after* yo checked the thermostat, changed, added or drained the system?
Dash board light isn't working 94 Chrysler lhs?
If the dashboard light on your 1994 Chrysler LHS isn't working, it could be due to a blown fuse, a faulty bulb, or a problem with the dimmer switch. Check the fuse box for any blown fuses related to the dashboard lighting and replace them if necessary. If the fuses are intact, inspect the bulbs behind the dashboard for any that may need replacing. Lastly, ensure the dimmer switch is functioning properly, as it controls the brightness of the dashboard lights.
Does the valves bend on a 94 2.2 sundance engine when the timing belt breaks?
AnswerThe Chrysler 2.2L and 2.5L 4cyl. engines produced from 1981-1995 are non-interference so if the timing belt breaks the engine will simply stop with no damage to engine parts.
Odb diagnostic connector outlet located on the 94 Chrysler 300?
There was no 1994 Chrysler 300.
Where is the alarm on a 94 Chrysler lhs?
On a 1994 Chrysler LHS, the alarm system is typically integrated with the vehicle's central locking system. The alarm may be activated through the key fob or by locking the doors manually. If you're looking for the physical components, the siren or horn is usually located under the hood, near the driver's side, while the alarm module can often be found under the dashboard or near the fuse box. For specific troubleshooting or disarming, consulting the owner's manual or a repair guide is recommended.
