answersLogoWhite

0

That depends on when it shakes.

Low speed, it could be a bad tire, bent wheel...

High speed, it could be a bad tire, bent wheel, out of balance wheel, worn ball joints, worn tie rod ends, worn idler arm...

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you check the rearend fluid in a 1992 Chevy G20 van?

plug on pumpkin on front of rear end on passenger side


Where are the timing marks on an astra van 8v?

Chevy astro van? on the front ballencer


Can you replace a 94 Chevy van rear end with a Chevy Suburban rear end?

It can be done, yes.


What size are the front speakers on a 1995 Chevy G20 van?

4.6


Where is the fuse box in a 2004 Chevy van?

standing in front of the van is under the hood on the right side


Where are the Chevy van tire jack points?

Side of van along the frame Behind front wheels and in front of rear wheels Side of van along the frame Behind front wheels and in front of rear wheels Side of van along the frame Behind front wheels and in front of rear wheels


Where is the fuse box in a 2004 Chevy Express van?

standing in front of the van is under the hood on the right side


How do you remove front coil springs on 1993 G20 Chevy van?

ejaculate on them


How do you replace a wheel bearing assembly on a Chevy G20 Van?

Front or rear?


What other Chevy rear end will fit under your 1990 Chevy van?

it has to be out of a van because the Axel housing in a van is longer than any other vehicle Even trucks.


How do I change the signal light in a Chevy Express van?

how to change front left turn signal bulb on a 2004 chevy express


What is loose on steering. jack wheel off ground feels loose when you grab wheel and try to turn it. 1993 Chevy truck?

Probably a outer tie rod end but it could be any number of things. While you shake the front end have someone look for play in front end parts. It could also be your wheel bearing sometimes called wheel hub bearing I just replace my wheel hub assembly my my van was doing the same thing and i also needed a outer tie rod