0
What else can I help you with?
How do you reset alarm system for 2002 grand am?
The factory alarm causing the issue would be the security light flashing above the RPM guage. If the security light is flashing and the car will not start, follow the directions listed below. To reset the factory alarm, turn the ignition switch to the "on" position NOT the start position for 15min. You will see the security light go off after 15min.
What if your car was stolen and you replaced the factory steering column with a salvaged fire bird steering column now your car wont start or even turn over and the security light stays on why?
why? did your car was stolen and you replaced the factory steering column with a salvaged fire bird steering column now your car wont start or even turn over and the security light stays on why?
What would cause your GMC Jimmy to only start after you have tried to start and then let it set for a few minutes?
It could be the factory security system, is the light (security) flashing? *depends on what it is doing. dead start, clicking, battery connection bad or battery dying/dead; sputtering, almost starting without sparking, the fuel pressure is low and needs to build before it starts; bad injector system, fuel pump, clogged fuel filter.
Why does my 99 Chevy silverado stay on security mode and not able to start?
are you using the factory key? they have security chips in them.
2002 Pontiac Trans Am V8 will not start starter vs security Will not start in neutral. security light is on when I attempt to crank then security light is off.?
if the light goes off it's probably the starter...
What will make the security light stay on in a 1999 S10 blazer it will start but will not stay running?
security light on 1998 s10 start but cut off
Why does the security light comes on and wont start?
ANWSER
Why is the security light blinking and the car won't start?
Not enough information regarding why the car won't start but as to he security light; it's always blinking when the engine is off.
Why does your dodge durango stop running when the security light goes on and vehicle won start for a while after?
The red light indicates a failure in the security system. It will not start with a failure.
What could be the problem if you changed the starter and the car still won't start?
factory security system. bad key, bad ign lock cylinder, switch etc. Get a test light, and check if you have voltage to the starter in the "start position". the runner is bad
Security light keep flashing car want start?
security light keep flashing put new starter on still will not crank
What if your car will not start the security light stays on .what do you do?
is your security light flashing? turn the key on, leave on for 10 mins, turn key off let it sit for 2 mins, start car
