0
What else can I help you with?
Hey tom its a 1990 pontiact transport van and it starts out fine and as soon as the vehicle warms up it will stall it will start back up but when you put it in gear from park it stall again until cool?
Hey tom its a 1990 pontiact transport van and it starts out fine and as soon as the vehicle warms up it will stall it will start back up but when you put it in gear from park it stall again until cool?
Why does your 97 Saturn SC2 start rough run fine then stall when you put it in gear?
vacuum leak,map sensor
What could be the problem if your 92 Chevy Corsica is driving fine and then it starts to sputter and stall it cranks back up and stalls when put in gear?
TCC Solenoid.
Why does my 2004 Xterra stall when put in gear It Starts idling at 1200 rpm after 15 min it idles down and drives fine?
Look for a vacuum leak.
I have a 350 Chevy motor in my truck It starts fine and idles fine but when I put it in gear it stalls Wondering what the problem might be?
if you got an automatic depending on what gear it is you may need a 2800 or 3500 rpm stall in your torque converter call a transmission shop if that's it they will help you
Can you stall or is it just harder to stall a manual car while driving at speeds over 40?
It depends on the gearing of the car. If you are in the highest gear and 40mph in that gear is under the idle rpm of that car than you will stall.
You have 1994 Cadillac Seville that keep cuting of when you put gear?
i have 94 cadillac sadillac that keep cut off when in gear
Why does a 1991 Pontiac grand am stall when put into drive?
I had the same problem with my 1992 grand am after it got warmed up. Once it cooled down it would go just fine. I determined that the torque converter lockup solenoid was bad and would not disengage once the transmission got hot. It will seem like you are dropping the clutch when you put it in gear, because the trans is locked in gear.
Why would a Mazda MX6 manual transmission stall when put in gear?
Ignition module is bad I had a similar problem on a Pontiac grand am- it was the torque inverter. It would idle fine, run in nuetral, but as soon as it was put into gear it stalled with a thump.
Why does car shake and stall?
Travelling to slow in a high gear, so clutch in and lower the gear.
Why does my 86 fiero stall when put in gear-idles fine-changed the iac--tps map to no avail.?
your tcc could be faulty, assuming its an auto. faulty neutral switch maybe
What makes a car stall and not go in gear when the engine is cold?
Check your transmission fluid level and also if the gear chamber is not well greased then it will make them stick causing the vehicle to stall.
