0
Why does your 95 probe GT idle rough after replacing the distributor plugs and wires?
If you're saying it started that after you replaced them, then of course, you need to check all the work. Are the wires seated correctly on both ends? Were the plugs the correct ones, and properly gapped? Were they tightened to the proper torque? If you're saying the rough idle is what you were trying to fix, then at least you've probably ruled out ignition. Next, you might consider the fuel system (dirty injectors, clogged filter, Throttle Position Sensor, etc); the vacuum system (leaks from loose or deteriorated hoses, etc.); or the EGR system (stuck or leaky valve, sticky solenoid, etc.). If you're getting a service engine light, it may be time to get the codes and see what they mean.
What else can I help you with?
Should your 95 probe gt idle rough after changing the distributor plugs and wires?
did you check if you had them in the right order, or if the plugs were fouwled? If you did not make a mistake with plug gaps, wire routing, check for a cracked or leaking vacuum hose. Perhaps you accidentally bumped one off its receiving end.
What can cause a m Mazda 323 1.6 to Idle rough after replacing spark plugs plug cables distributor cap rotor?
A rough idle in a Mazda 323 1.6 after replacing spark plugs, plug cables, distributor cap, and rotor could be due to incorrect installation or faulty components. Check that the spark plugs are properly gapped and fully seated, and ensure the ignition wires are connected securely and in the correct order. Additionally, vacuum leaks, a dirty idle air control valve, or issues with the fuel system could also contribute to rough idling. It may be helpful to perform a diagnostic scan for error codes to pinpoint the issue.
Does bad spark plugs give you a rough idle?
Yes. Bad spark plugs, bad spark plug wires and a bad distributor cap are the common causes of rough idling. If it has been a while since you changed these components, do so.
What would make a 1996 Chevy c1500 305 run rough outside of plugs and wires?
Corrosion inside the distributor cap. Get a new cap and rotor.
If a 1993 Geo Tracker has a rough idle and you have replaced the plugs wires distributor cap rotor and fuel filter what is next?
try checking youre timing
Why does an engine run roughly?
if it's runninng rough my guess could be spark plugs are fouled up. if not then next check the spark plug wires then the distributor.
1995 lebaron V6 runs rough after replacing all outer ignition parts?
Check distributor cap Also check vacuum hoses if one is cracked or not connected it will cause car to run rough
Why does your truck run rough after changing the distributor cap and rotor?
Rough Engine Performance AFTER Changing Distributor Cap and RotorThe only thing I can think of is that in the process of the changeover, the wires between the newly installed rotor and the spark plugs were not reconnected to the proper "towers."As a result, the spark plugs are not firing in the proper order thus causing the rough running. Since the engine will run, I also suspect that possibly only one or two plug wires are improperly connected.
What causes the 3.3 buick engine to run rough or not start after replacing the plugs and wires?
check spark plug gap and firing order-also check to make sure plugs are tight and wires connected
Wifes car running rough Found a wire missing from distributor do not know what goes there Help is there a diagram of the wires?
Look at the spark plugs-- if one has no wire at the top, that is the problem- there should be a wire from each spark plug to the distributor cap.
Why does your Chevy 4.3L V6 Cheyenne idle rough you have replaced plugs plug wires distributor cap and rotor?
I would recommend checking for codes before you do anything else.
What make the car to idle rough you changed the plugs?
When the idle goes rough, you must idle the plugs. Else the car plugs roughly.
