Low beams are burned out.
the
Location 30 ; 10A fuse; Labeled "Parking lamps" in manual. Just replaced mine and my tail lights, dashboard lights, parking lights, and the dinging that goes off when the lights are on all came back. I had to remove the CD Storage box (push two tabs on the inside inwards and pull box out), pulled out #30 fuse (not #32 as I saw on other posts), saw that the wire was broken, put in a new one, tested the parking lights, and all good. Hope this helps. -Swen
into
into
It is your fault.
Yes, connected to the parking brake assembly is a little black lever, which when pulled will manually release the parking brake.
hi while parking near the petrol bunk the ignition was not switched off vendor pulled the petrol cap but it is locked now how to fill the petrol now please explain
It sounds like the ground for the parking/turn signal circuit is bad on the damaged side. You mentioned sufficient power to all lights, I assume this applies to the parking/turn signals too. If this is not the case check the main fuse box for disconnected, pulled-out connections. Hope this helps,
Backing up--it is your fault.
The actual problem is the starter continues to turn after key is turned off and pulled out of ignition.
Parking Brake Theory doesn't work, I even tried unplugging the fuse that is supposed to control this but that didnt appear to work either? As far as I know you can't. They are on for safety reasons. There is a switch that is conected to a hand brake. When brake is engaged (pulled up)lights should go off.