I do not fully understand what you are asking. The psi of the tire is based on what vehicle it is mounted on. The same size tire mounted on two different vehicles may have totally different psi requirements. The correct pressure is listed on the vehicle driver's door post or another place on the vehicle. The psi listed on the sidewall of the tire is not the correct pressure that you should use when airing up the tire. That figure is the MAXIMUM pressure the tire can hold.
I do not fully understand what you are asking. The psi of the tire is based on what vehicle it is mounted on. The same size tire mounted on two different vehicles may have totally different psi requirements. The correct pressure is listed on the vehicle driver's door post or another place on the vehicle. The psi listed on the sidewall of the tire is not the correct pressure that you should use when airing up the tire. That figure is the MAXIMUM pressure the tire can hold.
I know of no vehicle where the engine has to be removed to change a timing belt.
The fuel pump is mounted in the gas tank. The gas tank has to be removed to change it.
The mass of the space vehicle will not change while in orbit unless parts are added or removed. However, the weight of the space vehicle will fluctuate due to changes in gravitational forces as it orbits different celestial bodies.
of course. you should change your sand every 8-10 years. use a shop vac to get it out.
how do you change the high mounted stop light on a lexus Is300?
You will need a new central mounted brake light bulb for your vehicle. Changing it is very easy. You just need to pull the old one out and push the new one in.
The alternator must be removed and replaced from the bottom, as with raising the vehicle high enough to work from underneath "safely".
The horn on a 1997 Hyundai is found mounted on the bumper of the vehicle. Remove the bolts that hold the horn down. Unplug the wiring and replace the horn.
The left pedal in a vehicle, known as the clutch pedal, is used to disengage the engine from the transmission. This allows the driver to change gears smoothly and come to a stop without stalling the engine.
The blower motor relay is mounted on the multi use relay and fuse bracket above the (BCM) body control module which is located on the right hand side of the vehicle mounted to the toe-board behind the carpet...........
The slave cylinder is mounted directly over input shaft on transmission behind clutch. Unfortuantely the transmission must be removed to access it. You will see it bolted to tranny once you get it out.
A person can change the back shocks on a 1995 Chevy Caprice by unmounting them from the upper lower mounts. The shocks can then be removed from the vehicle and new shocks put in their place.