answersLogoWhite

0

Broken wire or wire connection at the switch and/or fuse. You can check for any voltage present at those locations with a simple volt/ohm meter.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you install power window switches for a 1977 Corvette?

How do I replace the power window switch on 1977 Corvette coupe


Where is power window relay on a 1973 Corvette?

I have a 1972 Corvette and the power window relay is in the shifter console, just forward of the power window switches. I would believe it's in the same place in the '73. Good Luck


Where is the power window fuse on a 1992 corvette?

The 1992 Chevy Corvette power window fuse is located in the fuse box. The power window fuse will be in the second column, second from the top.


Why does the Power window on the passenger side not work after both switches have been replaced?

power window moter is bad.


How do you Adjust power window travel on 77 corvette?

The power window travel for a 77 Corvette is adjusted by bolts that are in slotted holes. Remove the door panel. Make small adjustments to each adjustment slot until the window travels properly.


No power to window switches 325i BMW?

replace your comfort relay


How can you tell if a power window relay is bad on a 1974 corvette?

put in a new relay... if the window works it was a bad relay


How do you remove window switches from 96 E320?

removeing main window power control board 1997 e320


Why do power door locks quit working on a 1979 Corvette?

If the power door locks quit working on a 1979 Corvette, it is due to broken pigtail switches. With age and use, the pigtails break and leaves the power door locks inoperable.


How do you find a power window diagram for a 78 Corvette?

The 1978 Corvette power window diagram can be found in the cars maintenance and repair manual. A person can get these manuals at an auto part store.


Where or what is the power source for the rear electric windows on a 1986 Mercedes 300 E?

Right windows (front and rear) are fuse H, and left windows fuse G. 1. The power(for all the windows) flows through the K4 power window relay. That relay is powered by fuse #2. 2. Than the power flows through fuses G + H, and to the switches in the forward rear window switches in the center console by the shifter. 3. Power goes through the front switches, to the rear switches, and than to the window motors. 4. Ground is supplied to the motors through the switches as well. Ground to the rear switches is controlled by the "rear window safety switch" located between the front and rear window switches on the center console. - - ----I just sat here for five minutes trying to put into words a description of the the operation of the switches and power flow to the window motors. I cant say I can do it w/out really confusing everyone. If anyone really needs an operational description just message me. Hope this helps.


How do you replace drivers power window ribbon on a 1985 corvette?

cannot get old ribbon rfom slide