power window moter is bad.
Usually the switch. It should be replaced, or (if you're so inclined) it can be taken apart and repaired. Careful of Chinese made switches (not worth using).
give more detail to jjmrsf@nctc.com and I will try to help.
If you can operate the window from the driver's side, then you need to replace the switch on the passenger's side. If neither side works you need to replace both switches. You buy the switches at any auto parts store. They are fairly cheap. The cover on the window-control panel can be easily removed. If there are no screws, just pry it up.
I would check the switches first then check the window motor for passengers side.
i have a 2001 Nissan altima and the power window switch had a problem... only the drivers window had a problem. I took it to the dealor b/c there is a recall on the power window switches and they replaced all 4 for free. Not sure if the 2000 year has the same recall, but it's worth checking out.
How do I replace the power window switch on 1977 Corvette coupe
There is only one fuse for all power windows. If only the passenger side window does not work, the problem is either with the passenger window switch or the motor on that window.
replace your comfort relay
First determine the problem Remove door panel to see if power is getting to motor--if so motor is bad--if not could be switches or wiring to same
the wheels
If it is a power window, there is a motor inside of the door that controls the motion of the window. These motors are prone to failure and cost about $280 at a dealership to have replaced. Answer #2: I have a '99. The passenger window is bad. I lubed all the cables to some inprovement but no avail. I checked the power delivery and switches... all work fine. I cleaned the motor and then replaced it. Still intermittent action. Goes down better than up. It goes up by holding the drivers switch up and pulling/shaking the window while shutting the door. Sometimes you drive a few miles and it will go up a little more. I'm thinking the whole regulator assy needs to be changed out. I am quite confident the switches and wiring are ok. I know the motor is ok.... therefore it is probably the regulator assembly itself.
removeing main window power control board 1997 e320