0
What else can I help you with?
Why will motor only start by adding gas to carburetor will idle fine after motor fires but wont shut off and start back up?
The carburetor needs rebuilding.
How adjust carburetor on Yamaha g16 golf cart?
To adjust the carburetor on a Yamaha G16 golf cart, first locate the adjustment screws on the carburetor. Start by turning the idle mixture screw clockwise until it gently seats, then back it out about 1.5 turns. Next, adjust the idle speed screw to set the desired engine idle RPM, usually around 1,200-1,500 RPM. Finally, fine-tune the mixture and idle speed as necessary for optimal performance.
Why does your motorcycle idle fine but bog out when in gear?
Your motorcycle might idle fine and bog out when in gear because of a problem with the carburetor or the bowl. If either area is dirty, it will often bog the bike when in gear.
What would cause a Chevrolet 350 to not idle it will start and run under throttle but will not idle at all?
vacuum leak? carburetor adjustment?
How do I adjust a carburetor for a Murray 3.5 hp push mower?
To adjust the carburetor on a Murray 3.5 hp push mower, first, ensure the engine is off and cool. Locate the idle adjustment screw, usually found on the carburetor, and turn it clockwise to increase the idle speed or counterclockwise to decrease it. Start the mower and let it run; fine-tune the screw until the engine runs smoothly at idle without stalling. Additionally, check the air filter and fuel supply for optimal performance.
What is a idle port in Car?
Rephrase, Idle air control, idle circuit carburetor or
How do you repair rough idle?
Does this vehicle have a carburetor or is it fuel injected? In any case start with looking for vacuum leaks.
Suzuki samurai how to adjust the Carburetor?
hi I have. A 1988 samurai and when I start it up it will not idle up at all I have to give it gas to idle up wondering if there's something I can do.
How do you adjust the carburetor on a Chrysler Fifth Avenue?
Start at 1 1/2 turns from seat and then adjust for best idle
How do you adjust a 71 ranger carburetor?
Start at 1 1/2 turns from seat and adjust for best idle at that point
How do you adjust carburetor on weed eater featherlite sst25?
The carburetor on a Weed Eater Featherlite SST25 is adjusted by turning the screws on the side of the carburetor. They control the idle mixture and idle speed of the engine.
How do you adjust 3AU carburetor?
To adjust a 3AU carburetor, first ensure the engine is warm and running smoothly. Start by setting the idle speed screw to achieve a steady idle, typically around 700-800 RPM. Next, adjust the mixture screw (usually located on the side) to obtain the best idle quality, turning it in until the engine stumbles, then out until it runs smoothly again. Finally, fine-tune both screws as needed for optimal performance.
