0
What else can I help you with?
Why doesn't your headlights turn on for your 1989 Chevy Suburban?
start by checking your fuses.
On my 2003 Chevy suburban the wiper blades don't stop when you turn off the switch?
On my 2003 Chevy suburban the wiper blades don't stop when you turn off the switch sometimes, i would appreciate any help at all
Chevy suburban has delayed start Why have to turn the key four times to get it to turn over.?
You might have a battery problem, you could also have a starter or an alternator problem. It is best to take it in to be tested right away and go from there.
How do you reset the change oil light for a 2001 Chevy suburban LS 1500?
Turn key on do not start, push gas pedal all the way to the floor and let all the way off 3 times then turn key off then start truck.
If you have full power to your 1997 Chevy Suburban but not even a click when you turn the key why would that be?
transmission not in park
What direction do you turn the bolt on the crankshaft pulley on a 2005 Chevy Suburban?
Righty tighty, lefty loosey.
How do you remove a 1996 Chevy Suburban turn signal arm?
In order to remove the turn signal lever from a 66 Suburban you have to remove the steering wheel then there is a single Phillips head screw that holds the arm to the switch.
How do you unlock a 2001 Chevy Suburban?
Put the appropriate key in the door, and turn. Or use the remote if you have keyless entry.
Whats wrong 98 Chevy Suburban will not start the lights and radio work and it will not jump?
I had the same thing happen to me and my 96' suburban. It turned out to be that the battery was shot and wouldn't hold enough of a charge to turn over the engine. Might be the same thing with you.
Why will my My 2002 suburban turn over but won't start?
Is the fuel pressure ? is there spark at the plugs?
How do you access the round overhead map lights on a 1997 Chevy Suburban?
push in on the light with your finger and give it a quarter turn
How do you reset the anti-theft on 1999 suburban?
To reset the anti-theft system on a 1999 Chevrolet Suburban, first ensure the vehicle is in the "Off" position. Insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in the "On" position for about 10 minutes; you should see the security light turn off after this period. Afterward, turn the ignition back to "Off" and then start the engine.
