answersLogoWhite

0

Check the fluid level in the clutch reservoir. If it is empty you have found the problem. An empty reservoir means you have a leak in the system. It could be the clutch master cylinder, the clutch slave cylinder or a hydraulic hose that is leaking. Any air trapped in the hydraulic system will give the clutch pedal poor performance so, simply filling the empty reservoir may or may not restore the clutch operation.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Will a 95 S10 2.2 transmission into 95 S10 4.3?

no it wont but a 2wd Chevy silverado 700r trany will. besides that a 2.2 you will have to replace the clutch alot


How can a adjust the clutch pedal on my 1993 Chevy s10 pickup to make it disengage the clutch closer to the floor?

where and how to adjust clutch pedal 1993 s10 It is hydraulic operated, there is no adjustment.


Where is the clutch cable for 1999 Chevy S10 2.2L?

It doesn't have a clutch cable. The clutch is hydraulically operated.


Chevrolet discontinued clutch pedal for 1983 s10 what replaced it?

Not sure what you're asking about. I have a 1998 S10 standard shift that still has a clutch pedal.


How do you replace clutch cable in 98 s10?

It doesn't have a clutch cable. It is hydraulic operated.


How do you disconnect cable clutch on Chevy S10 on 2002?

The clutch is hydraulic operated, there is no cable.


Why wont your shifter go in gear after installing clutch kit on a 1989 ford ranger truck?

if you had this same problum befor u installed the new clutch the trans is stuck betten gears if you can push the clutch in and the veh will roll andyou cant shift it you just mite have put the clutch disc.in back word now till me dose you clutch peddle stay on the floor when you push it in?


Why wont my 95 neon start after changing the clutch cable can't even push start it.?

the clutch has to be pushed in to start. there is a switch under the dash probably knocked it out of position. while changing cable.


Why wont mt 91 ford escort GT start when you push the clutch in It does nothing and all the electrical works?

you may need a new clutch or there may me some sort of sensor or switch that is bad


How do you change a clutch in a 92 s10 pickup?

you need to remove the transmission then unbolt the clutch from the flywheel.


How do you replace a clutch in a 1995 s10?

Remove the transmission. Remove the clutch plate and springs. Remove the clutch. Reverse the process to install the new clutch.


S10 hydraulic clutch line disconnect?

I need to replace release bearing in a 1995 Chevy s10 truck and need to know how to disconnect the hydraulic clutch line for the transmission.