answersLogoWhite

0

The manual transmission has a starter interlock which prevents the engine from

cranking unless the clutch pedal is depressed

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you reset the fuel pump on a 1991 ford ranger?

Push the reset button.


How do you adjust the steering wheel of a 2003 ford ranger?

To adjust the steering wheel of a 2003 Ford Ranger, locate the lever underneath the steering column. Pull the lever down to unlock the steering wheel, then adjust the wheel to your desired position. Once adjusted, push the lever back up to secure the wheel in place. Make sure it is locked before driving for safety.


How do you reset fuel shut off switch 1994 ford ranger?

push the button down


Noises when you push gas pedal?

ticking noise when the gas pedal is pressed in a 2005 ford ranger


Where is the fuel filter on 2002 ford ranger?

i have a 2003 ranger with a 3.0 L i tried to do the same thing the clips do not come off you have to push and pull them every body told me pry them off so i did and broke both fuel lines costing me 200 dollars to replace them i hope this helps you


Can you push start a 2003 Manuel car without a key?

Not without the key, no.


How do you change a window handle on a 2000 Ford Ranger?

it requires a slide tool to push u clip out. most parts store have tool


Where is the schrader valve on a1989 Ford Ranger?

It is the tiny valve that lets air in to your tire but not out (unless you push it in with a nail or similar "pointy" thing)


Have a 1993 ford ranger 4x4 manual trans and just quit cant shift to any gear?

When You Push The Clutch In Make Sure Its To The Floor


You push in the clutch on a 1999 ford ranger and turn the key and nothing happens This does not happen every time?

switch under dash on clutch is bad


Why won't ford ranger diesel push start It has manual transmission.?

Because you have to have the clutch depressed to start it. They came factory with a clutch safety switch that will not allow the engine to start unless the clutch pedal is pressed to the floor . NOT. the clutch safety switch only allows the starter to be energized... If the glow plugs will cycle then the truck can be pulled to start. When my starter solenoid was bad I pulled it to start.


How do you remove the hydraulic clutch line from the slave cylinder on a 1992 ford ranger?

push in line pull back teflon sleeve evenly then pull back