That car uses a single type 9004 bulb on each side of the car. The 9004 contains two filaments, one for low beam and one for high beam. If the high beams work but the low beams do not, then either the low beam filaments in both bulbs have burned out or there is a fault in the low beam feed circuit.
change the head light swicth
i am not trying to insult your intelligence but it may be as simple as both bulbs burning out at once access the fuse panel and check to see if the headlight fuse is blown, in most cases since headlights use a lot of power they are put on their own circuit.
Headlights, interior lights, parking lights,Headlights, interior lights, parking lights,
Not if headlights are reqired by law.
parking lights are in the back of ur car and headlights ar in front of ur car
no, you may not, because ,driving with just your parking lights only( in place of your headlights) is against the law
Check the fuse for the headlights. It is probably open.
They don't
yes
The headlights work on a totally different relay than the parking and fog lights. The headlight relay or headlight fuse is usually blown when only the parking and fog lights work.
The parking lights are turned on when the headlights are on and you pull out on the light switch. The parking lights cannot be turned on by themselves.
I HAD THE SAME PROBLEM & FOUND THAT THE WIRE TO THAT LIGHT WAS CHAFED.CUT OUT A SMALL SECTION OF THAT WIRE,CONNECT TOGETHER (DON'T FORGET TO PUT ELECTRICAL TAPE OVER REPAIR & AROUND SURROUNDING WIRES TO PREVENT REOCCURANCE!!) & PRESTO!! YOU SHOULD HAVE LIGHT!! GOOD LUCK