0
What else can I help you with?
Why would a 1994 BMW drive normally in reverse but barely move at all when in drive?
I had a 1990 535I mine did that, took offf from a stop light and it moved about 5 ft. then the trans program indicator came on. It drove in Reverse just fine, made some phone calls and $1800 later I had a rebuilt tranny. Hope that helps
Why would a car stall in drive but not in reverse?
Because reverse is a lower ratio gear than drive and puts less load on the engine.
Why would your 1995 Buick run in park neutral and drive in reverse but stall when put in drive?
* cause it needs to be put in drive to go forward
Why would a 2004 Ford Freestar jerk when you drive in reverse?
I would check and see if you have a transmission or PCM problem.
Why would a car not go in drive or reverse when it has been off for a while?
Check your transmission fluid.
Why would a 95' eagle summit drive fine in forward gears but not go in reverse?
Tranny is going out
Why would a 2003 Chevy impala roll backward in drive and forward in reverse when on inclines?
Weight of the vehicle
What are Probe owners clubs?
I would think a Probe owners club is for owners of Ford Probe cars.
What would make an automatic 94 Olds Ciera LS only run in reverse and barely run in the lowest drive gear?
assuming the fluid level is ok, and that it is transmission fluid and someone did'nt stick engine oil in the tranny....it sounds like its time for a transmission overhaul.. good luck
What is the difference between going around Australia anticlockwise and clockwise?
drive normally clockwise but if you drive around anticlockwise you would have to reverse all the way and that would be very slow and annoying lol
What modifications do you need to do to fit a 305 in a 95 Ford Probe?
putting a 305 in a ford probe would be more expensive that buying a car that would outrun it in the end. ford probe is front wheel drive and the body and frame (unibody) will not come close to taking the weight or abuse that the v8 will expose it to. as far as modifications they would be MAJOR. into the thousands of dollars. dont waste your time. get an SHO motor from a probe and put it in there. it will run with most v8s comfortanly and at a huge savings to your wallet.
What would be the cause for the driverside front tire to lock when put in reverse but roll fine in drive on a 4wheel drive truck?
the rear front axle gear box would brake then it would snow drops of water
