0
: If anything, try replacing the fuel pump relay (about $17.00 part) before you do anything too expensive. I spent about $1200 replacing the computer and the pump and finally replacing the relay worked. It almost looks like a fuse and should be possibly located under the glove box (at least it was on my 95). Good luck.
What else can I help you with?
Will a 4.3 z engine from a 1992 s10 blazer fit in a 2000 s10 blazer?
It would bolt in but you would have fuel injection problems.
Would the computer in a 1984 Chevy blazer have anything to do with your engine not getting fire and not starting?
yes it would or it might be the starter
Why would your headlights stop working on a 1998 Chevy blazer?
Check bulbs, fuses, and check for wiring problems
Can you bypass the fuel filter on 1997 Chevy blazer?
Bad ideal. Why would you want to ? It would just cause bad problems later.
98 Chevrolet Blazer will not turn over when starting what would cause this problem?
A broken timing chain is a possibility.
What would cause a grinding noise when starting your 1996 Blazer?
sounds like a bad starter gear or bad flywheel
What is wrong with a 1994 Ford Explorer that will just shut off but will restart in 5 to 15 minutes?
Check the fuse panel for the fuel pump relay fuse...it may be "stuck" in open..this way you would get the intermittant problems you are referring to.
Would you have problems starting your car if you didnt start it for a year?
Almost certainly.
Would an automatic transmission from a 1997 Blazer fit a 1996 Blazer?
yup
Which oxygen sensor should you change on your 1999 Chevy blazer back firing problems?
If it had a bad O2 sensor the "check engine" would be illuminated and a code would be set indicating which sensor is at fault. You probably have other problems causing that backfire to occur.
Why would a 1996 Nissan Maxima starter fuse blow when attempting to start the car but it did not happen when the mechanic started it?
Intermittant short?
What causes intermittant ignition spark?
Just a suggestion. I would look into the condencer on the coil you will see it hanging on the right side if the coil.
