answersLogoWhite

0

Bulbs burnt out? Bad hi-low beam switch? Voltage spike?

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Why both headlights are out on a 2001 Ford Escape?

Both headlights might be out on your 2001 Ford Escape because you have blown a fuse or several fuses. You also might have light bulbs that have burned out.


Why would Both of your headlights blew out at the same time?

The correct grammar would be "Why would both of your headlights blow out at the same time".


2001 Toyota Camry both low beam headlights stop working. jiggle sockets and they work again for a few weeks?

A reset button for headlights?


If both headlights went out would it be the fuse and not the bulbs?

Yes, I would start with the fuse.


What year headlights will fit a 2002 mercury cougar?

Both '01 and '02 headlights will fit the '02, headlights from '99 or '00 will not as they are longer and would not fit in the same space.


Why would both headlights go out on a 1989 Oldsmobile cutlass ciera?

fuse


What would cause both the turn signal and brake light fuses to blow on a 2001 Ford Escape?

short circuits in the turn signal and brake light circuits


How come the headlights won't go on on 2001 ford windstar?

The headlights of a Ford Windstar may have problems going on if they are burnt out or if there is a wiring problem. Blowing a headlight fuse will also lead to both lights not working.


Why would the bright lights not work on a 2000 Mazda B2500?

Switch? both headlights?


Why did both the headlights on your car go out?

if both headlights went put it is probably a blown fuse


Where is a horn relay on a 2003 ford escape?

The horn relay is in the fuse box by the passengers left foot. Not sure how to get at it though


How do you adjust the headlights on a 2001 Chevy tracker?

To adjust the headlights on a 2001 Chevy Tracker, park the vehicle on a level surface facing a wall about 10-25 feet away. Turn on the headlights and mark the center of the light beams on the wall with tape. Adjust the vertical and horizontal screws on the headlight assembly until the top of the beam is at or just below the tape mark and the beam is centered. Repeat for both headlights to ensure proper alignment.