0
Why would the battery light only come on when you press the gas pedal on my 98 ford contour?
If the battery light on your 1998 Ford Contour only comes on when you press the gas pedal, it may indicate a problem with the alternator or charging system. Pressing the gas pedal increases engine RPM, which should boost the alternator's output; if the light comes on during this time, it could suggest the alternator isn't generating enough power to charge the battery. Additionally, a loose or worn serpentine belt could be slipping under increased load, affecting the alternator's performance. It's advisable to have the charging system tested to diagnose and address the issue properly.
What else can I help you with?
1995 subaru legacy outback Why is brake-battery light on just replaced battery and alternator but brake-battery light still on goes off when car is idle but comes on when you press gas pedal?
Put some brake fluid in the master cylinder.
How can I reset the check engine light on a 2000 Toyota Echo myself?
You discount the negative cable from the battery and press the brake pedal for at least ten seconds.
How do you reset the change oil light on a 2004 grand am?
To reset the light, turn your ignition to on, then press the gas pedal 3 times, then start the car. To reset the light, turn your ignition to on, then press the gas pedal 4 times then you will hear a beep, then start the car.
How do you reset the change oil light in a 2001 Chevy Silverado?
Turn the ignition set to on without starting the engine. Press the gas pedal three times in quick succession and watch for battery light to flash three times, when it does, it is reset.
Why does signal light stop working when you press brake pedal on 2003 Kia Sedona?
possibly have a brake light out
How do you reset a check engine light on a 2001 mercury villager?
take it to auto zone and ask them to check and then clear the codes or remove the positive battery cable and press the brake pedal for 30 seconds.
How do you reset brake service light in a 2000 Chevrolet suburban?
turn key to on. press gas pedal three times. turn off key. this resets light. turn key to on. press gas pedal three times. turn off key. this resets light.
How do you reset the oil change light in a 2010 Mountain Wrangler?
Key on, engine off, press the gas pedal to the floor three times.Key on, engine off, press the gas pedal to the floor three times.
How do you reset the oil change light on a 2009 dodge Dakota?
Key on, engine off. Press the gas pedal to the floor three times.Key on, engine off. Press the gas pedal to the floor three times.
What causes the fuse to pop everytime you press on the brake pedal?
A short in the Brake light circuit? Bad brake light switch?
Why will the brake light not come on Fuse and Light bulb is good?
sounds like bad break light switch. your break pedal has a switch that turns on your break lights when you press on your breaks and off when you take your foot off the pedal.
How do you reset oil change light on 2008 dodge caliber?
Turn the key on, engine off, press the gas pedal to the floor three times.Turn the key on, engine off, press the gas pedal to the floor three times.
