As long as the 302 is from a similar year it will bolt right in. The only difference between the 289 and 302 is the 302 has a slightly longer stroke.
With manual 3 speed trans, 94 mph.With manual 4 speed trans, 92 mph. With automatic trans, 91 mph.
The vehicle speed sensor is on the top of the rear axle. The trans output speed sensor is on the driver side tail housing of the trans,
The bell housing is not the same on the two but if you are doing a change over from a automatic to a stick and have the trans and bell housing the will will fit where a automatic came out.
Yes it will the trans will bolt to the t5 bellhouseing and the v6 belhouseing will bolt 2 the5.0
Yes, it is located on the right axle shaft housing on the trans.
Back of the trans, in the housing that the passenger axle goes into.
In the transmission tail housing where the speedo gear would be in an older version.
That is on the tailshaft housing of the trans on the driver side.
On a 4 speed transmission it is the output speed sensor. That ir the sensor on the front of the trans farthest to the driver side. On a 3speed transmission it is on the housing that the passenger axle shaft comes out of trans in.
the sensor is located in the differential housing on the back of the transmission. (this is the speedomoter sensor, it is in the housing that the pass axle shaft slides into) For the 3.3/3.8L, it is near the bell-housing facing the firewall, as it senses the magnets that are on the torque converter when it spins. (that is the engine speed crank position sensor)
1 of 3 places.the bell housing the rear of the trans or in the rear end.
no.