Yes, a five-speed transmission can bolt up to a 350 motor in a 1995 S10, but you will need to ensure that the transmission is compatible with the engine and that proper modifications are made. This may include using an appropriate bell housing, adapter plate, and possibly custom driveshaft lengths. Additionally, you should consider the clutch and hydraulic components for a successful installation. It's advisable to consult specific compatibility guides or forums for detailed information on your setup.
change out the bell housing, ECU and motor mounts.. and your good to go
yes it will
its on the passenger side of the trans, towards the back of it. just take the bolt out and it should pop out.
Yes it will.
NO it will not. Not even close.
Chevy to Chevy...yes.
is the connector plate the same
No. blocks are not the same.
The transfer case will not bolt to a 2wd transmission.
probably But why would you want to?
You can replace your 1995 Chevy Corsica motor mount by loosening the motor mount retaining bolt. Jack the engine up approximately 3 inches. Remove the motor mount retaining bolt and the motor mount bushing. Put the new motor mount bushing in and reverse the process.
four bolts usually in top at back of motor under exhaust crossover pipe one above starter one in back of motor throught the motor and screwed into trans use flashflight, look above pass axle to where the flywheel would be.