answersLogoWhite

0

NO! You could run a compression test on an engine with NO intake manifold installed, so a leak of any size will not affect compression. The only things that usually affect compression is your rings, valves, and valve timing. if you have low compression on only one cyl, then valve timing is probably OK. With the piston at TDC removed the spark plug and introduce low pressure air (20psi) into the cylinder. If rings are bad, air will go into the crankcase (air comes out the oil cap), if air comes out the intake, you have an intake valve concern, if air goes out the tailpipe, you have a exhaust valve issue......Good Luck

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What causes a motor to backfire out of the intake manifold?

A leaking spark plug wire can cause a backfire out of the intake, but the most common cause is a burned intake valve. A burnt intake valve will allow leakage during the compression stroke back through the intake causing a popping backfire out of the intake manifold.


What cause misfire in 1 cylinder?

Bad spark plug? Bad plug wire? COP (Coil on Plug?) Bad coil? Bad valve? Do a compression test Bad piston? Do a compression test All of the above to include a vacuum leak such as a bad intake manifold gasket.


What goes wrong with 2007 dodge charger When your short runner valve go bad?

Normal cause is the intake manifold itself.Normal cause is the intake manifold itself.


What could cause a misfire on one cylinder after changing plugs wires ignition coil fuel injector and compression is at 180 pounds per cylinder and spark is getting to the cylinder?

I would make sure power is getting to the fuel injector use a noid light to test it. You may also want to check the fuel pressure also the intake manifold may have a leak that can cause a misfire as well. Glad your compression is good. That is a sure sign its something simple.


Why am I losing compression in cylinder 283 Chevy?

Bad are burnt intake or exhaust valve. Pistion rings broken, Burned pistion. Blown head gasket. That is all that would cause no compression are a loss of compression.


1999 jaguar xj8 losing compression from flooding?

If you have lost compression on several cylinders, and the car will not start, then its a cleaning problem and not a mechanical problem. The intake valves have got dirty and cannot seal very well, take off intake manifold and clean valves at the seat area. This should bring compression back. Usual cause is a commute of a mile or two, not allowing for complete engine warm up, lots of gook condensed in intake manifold. Richard


What will cause no compression in 1 cylinder only?

No compression in one cylinder can be caused by several factors, such as a blown head gasket, a damaged piston, or a broken valve spring that prevents the intake or exhaust valve from sealing properly. Additionally, excessive wear or damage to the cylinder walls can lead to loss of compression. If the cylinder is not sealing correctly during the compression stroke, the air-fuel mixture will escape, resulting in zero or very low compression readings.


Would a leak in the intake manifold gasket cause low compression?

no it will not. Bad rings will do it, Valves not seating in the head, Bad head gasket. Burnt piston will do it . These are things to look for.


Would a bad lower intake manifold cause oil to get in the water?

A bad intake manifold or manifold gasket can cause water to leak into the oil. Some newer cars have plastic manifolds and they will crack from age.


What would cause antifreeze to be where your spark plugs are in a 1997 Mercury Grand Marquis?

Intake manifold gaskets are leaking, intake manifold is warped.


Can a intake manifold gasket cause antifreeze to leake?

Yes. Antifreeze is actually pumped through the intake manifold. If the gasket is bad it is possible that it leaks out


What would cause vacuum leak in 2002 Pontiac Sunfire?

There are a few causes: Damaged or disconnected hoses (or component) from intake manifold. Worn out intake manifold gasket. Improper replacement of a part. Cracked or damaged intake manifold.