No it will NOT interchange. The 350 and 400 turbo are actually VERY different transmissions.
c4
There were turbo 350's with both a short and long tail shaft that fit a chevy. Long shaft were common from 71-76.
If you were to disassemble the entire transmission, the last part to come out would be the tail shaft.
9 inch tail shaft
no it will not fit at all
It would require the complete disassembly of the transmission because the tail shaft is the last part to come out of the transmission housing.
If you are talking about the SPLND STEEL center shaft that the driveshaft slides over, Then you will have to take the transmission APART to remove the shaft.
the 2wd turbo 350 has a longer tail shaft NEW ANSWER: The center shaft in a 4x4 transmission is longer then a 2 wheel drive trans. The reason is that it has a transfur case on the end of it, and the center shaft must fit into the transfur case to make it work.
The rear output shaft from a Turbo 350 transmission is not directly interchangeable with that from a Turbo 400. While both transmissions are used in similar applications, they have different designs and dimensions, including the output shaft length and spline count. If you need to swap shafts, it’s advisable to use the specific shaft designed for each transmission to ensure proper fit and function.
Yes, bolts right up.
i have a long tail shaft turbo 350 in mine, you have to modify the mount is all, it will fit
About 6 inches