0
Would it be better to replace a head gasket or put in a recon engine on a y reg fiesta zetec?
Bit of a tricky one ... It all depends on the condition of the cylinder head. If the cylinder head is warped then replacing the head gasket won't solve your problem. A warped cylinder head can be skimmed (if not too badly warped). If the cylinder head is badly warped then it would be much easier to replace the head than fit another engine.
What else can I help you with?
How to repair head gasket leak?
You should replace the head gasket. This repair is critical to the better performance of the vehicle, and to prevent future damage of the engine.
How do you replace the head gasket located on a 1995 Ford Fiesta SI?
take it to your local garage
Should you replace a blown head gasket or replace the whole engine?
Replace the head gasket for sure. That is assuming you did not continue to drive the vehicle until you destroyed the engine internally.
What is better to fix the head gasket or engine swap?
If all that is wrong is a blown head gasket and even a cracked head it is much easier and cheaper to just fix it than to replace the engine. The labor to replace the engine plus the cost of the engine would be far greater than fixing the one you now have. This is assuming the engine is not worn out already.
How much does it cost to replace an oil pan gasket on a 2006 impala?
about $600. Std. labor estimate is 5.47 hours to lift engine, replace gasket, replace engine and realign steering.
Do you have to replace the whole engine if the head gasket is blown?
No. You can have the head gasket replaced. This is unless you kept driving the car with a blown head gasket and have totally destroyed the engine.
How do you replace the head gasket located on a 1992 Ford Fiesta?
Replacing the head gasket on any vehicle is a long and complicated process, however if you wish to see basic step-by-step instructions go to the related question on the right side of the page "How do you replace a head gasket?"
Where is the thermostat located and how do you replace it on a Ford Fiesta zetec s?
The thermostat on a Ford Fiesta Zetec S is typically located near the engine, often at the end of the upper radiator hose where it connects to the engine block. To replace it, first, ensure the engine is cool, then drain some coolant, remove the hose, and unbolt the thermostat housing. Replace the old thermostat with a new one, ensuring the gasket is properly seated, and reassemble by reversing the disassembly steps. Always refill the coolant and check for leaks afterward.
How do you replace the head gasket located on a Ford Fiesta Popular plus?
Replacing the head gasket on any vehicle is a long and complicated process, however if you wish to see basic step-by-step instructions go to the related question on the right side of the page "How do you replace a head gasket?"
If head gasket jumped is he better to rebuilt the motor?
The four cylinder Fiero engine has a bad problem with cracking the cylinder head. If the gasket is bad it is likely the head will need an expensive repair. If the car has the V6 engine it is possible to just replace the gasket The real question is how good was the engine before the gasket failed? Should it be rebuilt or was it not burning oil and in good condition before the failure. Did the gasket failure cause any damage to the engine?
How do you changes a sump gasket on a Ford Fiesta 1998?
how easy is it to change a oil sump gasket on a ford fiesta 1.4 diesel 2008
Do you have to drop the engine on a Cadillac STS 1996 to replace the head gasket?
If that is the Northstar engine, yes.
