answersLogoWhite

0

I have a 98 Windstar (3.8L)and the Vehicle Speed Sensor (code p1538) is located just above the transaxle passenger (right) side and is accessible from the passenger side (right) front wheel well. Although it is simple to remove and replace (one bolt and one electrical connector), it is not simple to get to unless you have a hoist. You have to lift up all four wheels and disable the auto-levelling suspension first. Then you have to remove the right front wheel and the rear wheel well panel to get to the part. Because I did not have a hoist (or four jack stands) I had pep boys do the work (about $50.00 labor). The part at auto stores runs about $15.00 if you have electronic (digital read-out) odometer, or about $28.00 if you have manual (or analog) odometer. However, mine turned out to be different alltogether and I had to buy the dealer part (none other would fit) for about $48.00. Turn Key at Pep Boys was about $100.00 Finally, make certain the new part has a new O-ring to prevent leakage. If not you might be have more problems down the road. All the ones I looked at (AutoZone and Pep Boys) came with the O-ring.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Where is the throdle sensor?

I'm trying to locate the throttle sensor in my 1992 Mazda 323


Where is crank sensor locted on 1993 Chevy lumuna car?

trying to locate crank shaft sencor for 1993 Chevy lumna trying to locate crank shaft sencor for 1993 Chevy lumna


96 ford windstar will not start when engine is warm any ideals?

The Windstar most likely has a part that is breaking down when it heats up. Check the ignition coil and crank position sensor to start trying to find the problem.


Where is the sensor for the theft system location on a 1996 Toyota Camry?

trying to locate a sensor for the theft system for a 1996 toyota camry please help someone


Temp gauge not working trying to locate sensor location in 1997 Mazda b2300?

Try heater hoses.


Do you have a diagram for where the speed sensor is on a 1999 ford windstar?

I spent over an hour trying to loosen the one bolt that holds the speed sensor in place. Finally I removed the exhaust pipes and had it replaced in five minutes.


Trying to locate the IAT sensor on a 1991 Mercury Cougar 38L?

it's located on the firewall right in back of the intake


Where can one locate the services of a masonic tiler?

One can locate the services of a masonic tiler at MSANA. They are the only website out there that can help anyone who is trying to look for their services.


Where is the amp located in the BMW x5?

my right front and rear right speaker do not work and trying to locate the amp can anyone tell me where it is?


How do you fix a windstar sliding door?

you have to just keep trying to open it


How do you fix a Windstar Back Sliding Door?

you have to just keep trying to open it


I'm trying to replace the wheel speed sensor on the differential. does anyone know where it is and how to replace it?

It is on the top of the rear axle. You remove the nut that holds the brake line, remove the hold down bolt, and pull sensor out.