0
I'm trying to replace the wheel speed sensor on the differential. does anyone know where it is and how to replace it?
Wiki User
∙ 15y ago
It is on the top of the rear axle. You remove the nut that holds the brake line, remove the hold down bolt, and pull sensor out.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you replace rear differential pinion bearing?
trying to replace rear pinion bearings 1993 ford aerostar, 7.5 rear differential...slinger washer on drive shaft side is stuck, cant get pinion shaft out, all differential parts have been removed...any suggestions?
What sensor is it that controls the dash light indicators for the four wheel drive and antilock brake system in a Dodge Dakota truck?
The Differential Speed Sensor that is mounted on the top/front of the rear differential. Spray it with some wd40 before trying to remove the retaining bolt and then pry it out.
Where is the crankshaft sensor located on a 2000 Chevy Cavalier Will the crankshaft sensor affect the timing?
if you cant figure it out you shouldn't be trying to replace it
How do you replace cv joint on 01 ford explorer?
I am trying to put CV joint into differential and i need to know how to make sure it is in.
Where is the crank position sensor located on a 1993 Infinity G20?
trying to replace crank position sensor but i have no ideal where to look it is 1993 infinity G20 could you help me find this sensor
How much to replace 2003 Dodge Intrepid sensors?
Without knowing what sensors you are trying to replace, there is no answer. Please re ask question about a specific sensor.
Your engine light keeps coming onoff you had auto zone read the computer program says you need to replace your sensor Where is it and how do you replace it on a 98 Ford ZX2 you don't have an owners ma?
What sensor are you trying to replace? More 411 required to anwer/help you...
How do you replace the rear speed sensor on a 2002 dodge Dakota?
On my 1999 Durango 4X4 with rear antilock brakes, the sensor for the antilock brakes, the speedometer, and the automatic door locks, is located on the rear differential. It's a magnetic sensor that has a retaining device, and slides into the top of the differential case. Getting the old one loose was challenging. The replacement went in pretty easily. Unplug the wire, remove the retaining hardware, pull or pry the old sensor out, put the new one in, replace the retaining hardware, and plug it back in. This instantly restored operation of the speedometer, and cleared the antilock brake fault. I didn't have to disconnect the battery to accomplish this, though for best safety to the computer, this would probably be a good idea. Also, supporting the truck with jack stands on the frame, so the differential is hanging off the the springs, greatly improves access to the area of the differential you're trying to get to. Even better is to get it up high enough to sit/stand under the truck.
How to replace speed sensor of 86 fiero I put new sensor in but trying to figure out if i snapped a part in my transmission or if the sensor itself is chain belt driven?
The sensor may be gear driven direct off the axle. No belt or chain.
Where is the iat on a 2007 Chevy silverado new body?
The Intake Air Temp sensor is integral to the Mass Airflow Sensor (MAF). It cannot be replaced seperately. The MAF sensor would need to be replaced if you are trying to replace the IAT sensor. - TechJK -----------------------------------
Reset brake wear sensor indicator?
Replace brake pads Thank you Captain Obvious. Can we get a real answer now? I replaced my brake pads and sensor is still lit. Trying to avoid disconnecting my battery.
How do you replace a transmission sensor in a '99 Hyundai Accent?
im sorry i got confused i was trying to ask a question i didnt pay atten on what i was doing
