0
You put an new ignition switch in your 2004 Chevy impala but your car won't start now your security light is flashing?
Edited 6-10-09
Cause is the passlocks contact behind the lock, The female end in the housing section are corroded and a simple solution would be to spray a very small amount of electrical lubricant or wd40 and the the security system should detect the new ignition when inserted.
What else can I help you with?
How do you replace ignition switch on a 1966 Chevy impala ss?
The 1966 Chevy Impala ignition switch can be removed by loosening the retaining ring at the top of the ignition switch. Remove the wiring harness. Reverse the process to install the new ignition switch.
How do you reset the security switch in a 2003 Bonneville?
Put the key in the ignition and turn it into the run position, but don't start the car. Leave the key in the ignition until the security light stops flashing. The car will start now.
How Replace ignition switch 02 impala?
how to program the new ign switch
Can you use a 2002 ignition switch on a 2001 Chevy Impala?
YES.....
Turns over won't start 2000 grand am?
If your security light is flashing, then you have had what is referred to as a "bad timing cycle" with your Passlok security system. Turn the key to the ON position, and wait until the security light stops flashing - This takes exactly 10 minutes.If the security light WAS flashing, then the 10-minute trick is only a temporary fix - You will need to have your ignition switch replaced.
What would make a ford contour not start after you changed the ignition switch?
You may have activated security system if theft light flashing when key is turned, needs reset.
How do you bypass the ignition security switch in a 2002 Oldsmobile alero?
Yes to bypass,Press on the brake, turn car to as then on let the carburetor fill then, put the car in neutral,then start. If the security light is flashing, the car will not start for 10 minutes. Do not try to start while light is flashing.
What might cause a 1998 Sierrea SLE not to startSecurity light flashes on message center if that matters?
If the security light is flashing you need to change the ignition switch it self. It is likely worn out.
How do you reset the computer on a 2001 impala that reads security lockout?
Its in the key switch
How do you reset alarm system for 2002 grand am?
The factory alarm causing the issue would be the security light flashing above the RPM guage. If the security light is flashing and the car will not start, follow the directions listed below. To reset the factory alarm, turn the ignition switch to the "on" position NOT the start position for 15min. You will see the security light go off after 15min.
Where is the ignition switch on a 2000 Impala not the cylinder and key?
on most cars the ignitions switch, is generally loctaed in side the steering column or under the dash above where your legs are when you are sitting in the drivers seat. Just had to have my 2000 Impala's Key cyilinder switch replaced. My mechanic explained to me that the electrical Ignition switch is directly behind the key cylinder.
Does anybody there know what an ignition switch for a 2003 Chevy Impala is?
Yeah sure, its that thing you stick your key into to start it.
