answersLogoWhite

0

more than likely a scan tool will have to be used, to clear the code that was set , when the ABS light came on.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

How do you bleed the brake lines after replacing brake pads on a dodge Dakota?

If you did not open any brake lines and only replaced the pads there is no need to bleed the system.


What makes your abs brake light turn on on your 2000 dodge Dakota?

either a bad sensor somewhere, or a connection is disconnected


I have replaced my coil pick up coil and checked the fuses on my 99 dodge Dakota with no spark where do i look now?

crank sensor


Dodge Dakota brake lights?

dodge 2001 Dakota brake lights won't burn Check the fuses. If the fuses are okay check the brake light switch.


Where your brake sensor on 2001 dodge stratus?

the brake sensor for the 2001 dodge stratus is located on the inside of the car under the brake paddle.


Does a 2001 dodge Dakota with tow package have a trailer brake built in?

The 2001 Dodge Dakota, with a towing package, has a trailer brake built in. The trailer brake is part of the towing package.


Where on a 1997 Dodge Dakota with a 2.5 liter engine is the mass air flow sensor?

There is not a mass air flow sensor on a 1997 Dodge Dakota.


What is the crank sensor location on a 1990 Dodge Dakota 3.9L V6?

Dodge Dakota V6's didn't have a crank sensor until 1992.


Where is the O2 sensor bank 1 sensor 1 on a 2006 Dodge Dakota?

On a 2006 Dodge Dakota bank 1 sensor 1 is driver side above the catalytic converter.


Where is the MAF sensor located on a 1999 Dodge Dakota?

A 1999 Dakota does not have a mass airflow sensor.A 1999 Dakota does not have a mass airflow sensor.


Dodge Dakota 3.9 flywheel have sensor contacts?

After about 1995 all Dakota flywheels would have sensor targets on them.


Dodge intrepid 1998 code P0340?

I have a 340 code replaced the crank sensor 3 times replaced the cam position sensor still did not fix it the Dakota runs fine but when it gets warm it will not start until it cools off.