After about 1995 all Dakota flywheels would have sensor targets on them.
located on the passenger side of the bellhousing. It detects notches on the flywheel/driveplate
located on the passenger side of the bellhousing, behind the trans dipstick tube. It detects notches on the flywheel/driveplate
How do I get to the flywheel bolts on a 98 dodge dakota to remove a transmission
Dodge Dakota V6's didn't have a crank sensor until 1992.
There is not a mass air flow sensor on a 1997 Dodge Dakota.
On a 2006 Dodge Dakota bank 1 sensor 1 is driver side above the catalytic converter.
A 1999 Dakota does not have a mass airflow sensor.A 1999 Dakota does not have a mass airflow sensor.
Depends on the engine. Should be on the flywheel.
The crankshaft position sensor is located at the rear passenger side of the engine, next to the flywheel. On V6 and V8 it is below the spark plug wire loom, near and slightly higher than the EGR tube / exhaust manifold junction.
On the intake manifold
It does not have a mass airflow sensor.
It does not have a mass airflow sensor.