0
Your infotainment system is stuck on trip computer cleared how can this be reset?
I had the same problem on '03 Saab 93 ss , i over cleared a warning message on the SID , which resulted in the "Trip Computer Cleared " message appearing , very simple fix just disconnected the battery for a few seconds and display returned to normal -reset clock and once car was moving information displayed again on fuel consumption & temp etc....
Hope this helps ,
Just had the same issue with my 2005 Saab 9-3. To reset the SID, remove the fuses from slots 3 and 14 on the side panel that holds all fuses---consult owners manual for precise location. Leave the fuses out for a couple of hours (I removed them overnight), and the SID display will reset....two hours or more is important, nothing happens if you simply remove the fuses and immediately replace them......good luck!
What else can I help you with?
How do you reset a computer on a 2001 Chevrolet Camaro?
Have the system scanned for codes. Make the necessary repairs andthen have the code cleared using a scanner.
Does the computer need to be reset after replacing the ignition system?
A computer should not have an ignition system.
You cleared the codes on a 2000 cadillac deville and now it won't start help?
disconect reconect computer should reset
When Ireplaced cam shaft position sensor the light stayed on and the computer says that it is still that sensor?
you need to do a system reset. push the setup button on your dash a couple times until it gives the option to reset. then hold the reset button for 3 sec. hope this helps. Have you cleared the original codes?
How to reset computer on 2001 Ford Ranger?
The evaporative system needs to reset. How?
Where is the reset button for fuel pump on a 2000 Chrysler Sebring?
A Chrysler Sebring does not have a reset switch. The fuel system is computer controlled with relays.A Chrysler Sebring does not have a reset switch. The fuel system is computer controlled with relays.
Were is the fuel pump reset switch for a 1996 dodge stratus?
Dodge does not use inertia/reset switches. The fuel system is computer controlled with relays.Dodge does not use inertia/reset switches. The fuel system is computer controlled with relays.
Where is the fuel pump reset switch on a 1996 Dodge Dakota?
Dodge does not use inertia/reset switches. The fuel system is computer controlled with relays.Dodge does not use inertia/reset switches. The fuel system is computer controlled with relays.
Is there a reset button in 98 Dodge Intrepid to get the computer system back on after a rear end collision?
A Dodge Intrepid does not have a reset switch. The fuel system is computer controlled.
Where is the reset fuel button on a 1998 blazer?
Chevrolet doesn't use fuel reset switches. The fuel system is computer controlled with relays.Chevrolet doesn't use fuel reset switches. The fuel system is computer controlled with relays.
How do you reset periodic inspection of proton suprima s?
To reset the periodic inspection reminder on a Proton Suprima S, you typically need to locate the inspection reset function in the vehicle's onboard computer system. This can usually be done through the infotainment system or dashboard settings. If you're unsure, consult the owner's manual for specific instructions or visit a Proton service center for assistance. Always ensure that the vehicle's inspection and maintenance are up to date before resetting any reminders.
How can the CMOS be cleared on the computer?
There are three ways to clear the CMOS on a computer. You can access the BIOS menu and reset the BIOS settings, you can use the motherboard jumper or clear it by reseating the CMOS battery.
