To remove a leopard gecko eye cap, gently moisten a cotton swab with warm water and carefully rub it over the eye cap in a circular motion. If the eye cap does not come off easily, consult a veterinarian for assistance.
Ignition rotor and cap? Remove distributor cap usually clips or screws Rotor should lift off - replace in same position should have a "key" slot to insure proper position Install new distributor cap and transfer wires one at a time to insure proper placement
No, ice cap is a common noun. It is only a proper noun if it is the name of something specific, such as Ice Cap, Alaska or Ice Cap Products.
disconnect battery. remove distributor cap screws/latch leaving the spark wires in place. remove rotor. may have a screw or it may slip right off. replace with new rotor and distr. cap. check proper orientation and transfer spark wires one at a time from old to new cap.
Gently remove the spark plug wires marking each one so to put them back in the same order. Remove the two small screws holding the distributor cap down with the proper size "torx" head screw driver. Remove the distributor cap. Remove the two small screws holding the rotor in place using the proper size "torx" head screw driver. Remove the rotor. Install new parts in reverse order. Take note that the rotor only fits one way. Take care not to cross thread the distributor cap screws or you will crack the plastic distributor base.
To replace the distributor cap in a Mitsubishi Diamante, first, disconnect the negative battery cable to ensure safety. Remove the ignition wires from the old distributor cap, taking note of their order for reinstallation. Unscrew and remove the old cap, then attach the new cap securely, re-connecting the ignition wires in the correct sequence. Finally, reconnect the battery cable and start the engine to ensure proper function.
Remove the cap from a teacup, what is left?
On the 2.8L V6 the distributor cap is held on with two screws. Unscrew the two screws and pull straight up on the distributor cap to remove it from the distributor.
Remove the center console/cupholder. Remove the interior doghouse. Remove distributor cap.
There is a black reservoir about a foot behind the battery on the 2001-2003- not sure about earlier models. Clean the cap and reservoir to make sure that no dirt falls in when you remove the cap. The cap has a built-in dipstick indicating proper level with both hot and cold level ranges. Fill the reservoir as needed to achieve the proper level.
Remove the pins that are in the back of the body, and remove the screws. That should loosen up the rear enough to remove the cap
The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
How do you remove gas cap for 2004 Lexus RX 330?